Ads
related to: pneumatic tire rolling resistance ratings
Search results
Results From The WOW.Com Content Network
Temperature: with both solid and pneumatic tires, rolling resistance has been found to decrease as temperature increases (within a range of temperatures: i.e. there is an upper limit to this effect) [59] [60] For a rise in temperature from 30 °C to 70 °C the rolling resistance decreased by 20-25%. [61]
SAE J1269 and SAE J2452 performed on new tires. SAE J2452 is a standard defined by the Society of Automotive Engineers [1] to measure the rolling resistance of tires. [2] Where the older standard, SAE J1269, produces measurements of rolling resistance under steady-state (i.e. thermally equilibrated) operating conditions, SAE J2452 produces measurements during a transient history of speed that ...
Starting in 1972 tires were specified by load rating, using a letter code. In practice, a higher load rating tire was also a wider tire. In this system a tire had a letter, optionally followed by "R" for radial tires, followed by the aspect ratio, a dash and the diameter – C78-15 or CR78-15 for bias and radial, respectively. Each diameter of ...
Low rolling resistance tires are designed to reduce the energy loss as a tire rolls, decreasing the required rolling effort — and in the case of automotive applications, improving vehicle fuel efficiency as approximately 5–15% of the fuel consumed by a typical gas car may be used to overcome rolling resistance.
In a non-scientific study (I looked at tires available from a national chain that fit my car), 85 percent of LRR tires had an “A” rating for traction, compared to 87 percent of Non-LRR tires.
Pneumatic tires also have a much lower rolling resistance than solid tires. Because the internal air pressure acts in all directions, a pneumatic tire is able to "absorb" bumps in the road as it rolls over them without experiencing a reaction force opposite to the direction of travel, as is the case with a solid (or foam-filled) tire. [26]