Ads
related to: 3.5 inch floppy disk interface adapter for mac desktop
Search results
Results From The WOW.Com Content Network
It supported all of Apple's 3.5" floppy disk formats as well as all standard PC formats (e.g. MS-DOS, Windows), allowing the Macintosh to read and write all industry-standard floppy disk formats. The external drive was offered only briefly with support for the Apple II, coming late in that product's life.
3.5-inch and 5.25-inch drives connect to the floppy controller using a 34-conductor flat ribbon cable for signal and control. Most controllers support two floppy drives, although the Shugart standard supports up to four drives attached to a single controller. A cable could have 5.25-inch style connectors, 3.5-inch style connectors, or a ...
Internal SuperDrive floppy drive on a Macintosh LC II. The term was first used by Apple Computer in 1988 to refer to their 1.44 MB 3.5 inch floppy drive.This replaced the older 800 KB floppy drive that had been standard in the Macintosh up to then, but remained compatible [citation needed] in that it could continue to read and write both 800 KB (double-sided) and 400 KB (single-sided) floppy ...
KryoFlux reads "flux transitions" from floppy disks at a very fine resolution. [6] It can also read disks originally written with different bit cell widths and drive speeds, with a normal fixed-speed drive. [7] The software is available for Microsoft Windows, [8] Mac OS and Linux. The KryoFlux controller plugs into a standard USB port, and ...
Circuit components of the external USB SuperDisk for Macintosh. The drive itself is the same size as a standard 3.5″ floppy drive, but uses an ATA interface. On the right is the USB-to-ATA adapter, which plugs into an intermediate fan-out and power supply daughterboard that is inside the rear of the Mac drive's casing.
With Apple Computer's release of the Apple IIGS, Applied Engineering followed with a TransWarp GS, which provided an accelerated version of the 65C816 processor on which the IIGS was based. Multi-function cards were a mainstay of AE's product offerings, of which the Serial Pro serial interface card was a typical example.
An external 5.25-inch floppy drive, matching the style of the IIc, was also made available. Later, 3.5-inch floppy storage became an option with the "intelligent" UniDisk 3.5 which contained its own miniature computer inside (CPU, RAM, firmware) to overcome the issue of using a high-speed floppy drive on a 1 MHz machine.
the four-pin polarized Berg connectors used to connect 3½-inch floppy disk drive units to the power supply unit, usually referred to as simply a "floppy power connector", but often also referred to as LP4. This connector has a 2.50 mm (0.098 in) pitch (not 2.54 mm).