Ads
related to: 1/2 drill chuck 1/2-20 bit set wood metal plate
Search results
Results From The WOW.Com Content Network
Fractional drill bit set by Craftsman. Fractional-inch drill bit sizes are still in common use in the United States and in any factory (around the globe) that makes inch-sized products for the U.S. market. ANSI B94.11M-1979 sets size standards for jobber-length straight-shank twist drill bits from 1/64 inch through 1 inch in 1/64 inch increments.
Example (inch, fine): For 7 ⁄ 16-20 (same diameter as the previous example, but this time with 20 threads per inch, which is considered fine), 0.437 in × 0.90 = 0.393 in (i.e., if the threads are to be fine, then a slightly larger diameter drill bit should be used before tapping the hole for the screw).
In wood, the brad point drill bit is another solution: the center of the drill bit is given not the straight chisel of the twist drill bit, but a spur with a sharp point, and four sharp corners to cut the wood. While drilling, the sharp point of the spur pushes into the soft wood to keep the drill bit in line.
A pin chuck is a specialized chuck designed to hold small drills (less than 1 mm (0.039 in) in diameter) that could not be held securely in a normal drill chuck. The drill is inserted into the pin chuck and tightened; the pin chuck has a shaft which is then inserted into the larger drill chuck to hold the drill securely. Pin chucks are also ...
The Jacobs Taper (abbreviated JT) is commonly used to secure drill press chucks to an arbor. The taper angles are not consistent varying from 1.41° per side for No. 0 (and the obscure # 2 + 1 ⁄ 2) to 2.33° per side for No. 2 (and No. 2 short). There are also several sizes between No. 2 and No. 3: No. 2 short, No. 6 and No. 33.
On a wood router (a hand-held or table-mounted power tool used in woodworking), the collet is what holds the bit in place. In the U.S. it is generally for 0.25 or 0.5 inches (6.4 or 12.7 mm) bits, while in Europe bits are most commonly 6, 8 or 12 mm (0.24, 0.31 or 0.47 in).