Ad
related to: toyota fuel pump troubleshooting chevy truck problems
Search results
Results From The WOW.Com Content Network
The recall concerns brake fluid leakage from the master cylinder (U.S. market and non-U.S. marketed Toyota Crown and Lexus GS350) and an electrical problem with the fuel pump, which would cause engine stalling (all markets except the U.S.).
Second big problem: GM's cost-cutters decided not to fit a water separator. Unlike gasoline, diesel fuel is subject to water condensation – hence the need for a water separator. Without one, water in the fuel becomes water in the engine, where it can rust either the cylinders or the complicated mechanical fuel injection pump.
It allows a V6 or V8 engine to "turn off" half of the cylinders under light-load conditions to improve fuel economy. Estimated performance on EPA tests shows a 5.5–7.5% improvement in fuel economy. [1] GM's Active Fuel Management [2] technology used a solenoid to deactivate the lifters on selected cylinders of a pushrod V-layout engine.
Since the electric pump does not require mechanical power from the engine, it is feasible to locate the pump anywhere between the engine and the fuel tank. The reasons that the fuel pump is typically located in the fuel tank are: By submerging the pump in fuel at the bottom of the tank, the pump is cooled by the surrounding fuel
6.2L fitted to a 1987 HMMWV. The original 6.2 L (379 cu in) diesel V8 was introduced in 1982 for the Chevrolet C/K and was produced until 1993. The 6.2L diesel emerged as a high-fuel-economy alternative to the V8 gasoline engine lineup, and achieved better mileage than Chevrolet's 4.3L V6 gasoline engine of the 1980s, at a time when the market was focused on power rather than efficiency.
In 1981, a Delco Electronics ECU was used by several Chevrolet and Buick engines to control their fuel system (a closed-loop carburetor) and ignition system. [10] By 1988, Delco Electronics was the leading producer of engine management systems, producing over 28,000 ECUs per day.
Upon introduction, the T100 was criticized for being too small to appeal to buyers of full-size work trucks, the lack of an extended cab, and the lack of a V8 engine; with the only available engine was a 3.0 liter V6, which was already found in Toyota's compact trucks and in the 4Runner. [4]
Injection pump for a 12-cylinder diesel engine. An injection pump is the device that pumps fuel into the cylinders of a diesel engine.Traditionally, the injection pump was driven indirectly from the crankshaft by gears, chains or a toothed belt (often the timing belt) that also drives the camshaft.