Search results
Results From The WOW.Com Content Network
By default, the output value is rounded to adjust its precision to match that of the input. An input such as 1234 is interpreted as 1234 ± 0.5, while 1200 is interpreted as 1200 ± 50, and the output value is displayed accordingly, taking into account the scale factor used in the conversion.
By {{Convert}} default, the conversion result will be rounded either to precision comparable to that of the input value (the number of digits after the decimal point—or the negative of the number of non-significant zeroes before the point—is increased by one if the conversion is a multiplication by a number between 0.02 and 0.2, remains the ...
conversion combination output units SI: square kilometre: km2 km 2: US spelling: square kilometer: 1.0 km 2 (0.39 sq mi) km2 sqmi; square metre: m2 m 2: US spelling: square meter: 1.0 m 2 (11 sq ft) m2 sqft; square centimetre: cm2 cm 2: US spelling: square centimeter: 1.0 cm 2 (0.16 sq in) cm2 sqin; square millimetre: mm2 mm 2: US spelling ...
default conversion combinations SI: square kilometre: km2 Q712226: km 2: US spelling: square kilometer: 1.0 km 2 (0.39 sq mi) km2 sqmi; square hectometre: hm2 Q35852: hm 2: US spelling: square hectometer: 1.0 hm 2 (2.5 acres) square decametre: dam2 Q23931040: dam 2: US spelling: square dekameter: 1.0 dam 2 (1,100 sq ft) square metre: m2 Q25343 ...
The National Institute of Standards and Technology formerly contended that customary area units are defined in terms of the square survey foot, not the square international foot, [17] but from 2023 it states that "although historically defined using the U.S. survey foot, the statute mile can be defined using either definition of the foot, as is ...
Many US tapes also have special markings every 16 inches (406 mm), which is a US standard interval for studs in construction: three spaces of 16 inches make exactly 4 feet (1,219 mm) which is the US commercial width of a sheet of plywood, gyproc or particle board. A dual scale inch/centimeter tape measure.
Set square, or triangle A set square is used in technical drawing, providing a straightedge at a right angle or another particular planar angle to a baseline. They are commonly made from clear plastic. The most common set squares are 45° squares, (one 90° corner and two 45° corners) and 60/30 triangles (a 90°, a 60° and a 30° corner).
Socket set with ratchet (above), four hex sockets and a universal joint. A socket wrench (or socket spanner) is a type of spanner (or wrench [1] in North American English) that uses a closed socket format, rather than a typical open wrench/spanner to turn a fastener, typically in the form of a nut or bolt.