Search results
Results From The WOW.Com Content Network
ESP32 is a series of low-cost, low-power system-on-chip microcontrollers with integrated Wi-Fi and dual-mode Bluetooth.The ESP32 series employs either a Tensilica Xtensa LX6 microprocessor in both dual-core and single-core variations, an Xtensa LX7 dual-core microprocessor, or a single-core RISC-V microprocessor and includes built-in antenna switches, RF balun, power amplifier, low-noise ...
Includes 14 color-coded 3-pin connectors for direct cable connection of servos, electronic bricks, etc., and 6 color-coded3-pin connectors to Analog inputs for electronic bricks, etc. Provides improved 3.3 V regulator supplying 500 mA, and optional 3.3 V operation. Switching regulator provides 5 V 2 A from up to 20 V external supply.
Includes 14 color-coded 3-pin connectors for direct cable connection of servos, electronic bricks, etc., and six color-coded3-pin connectors to analog inputs for electronic bricks, etc. Provides improved 3.3 V regulator supplying 500 mA, and optional 3.3 V operation. Switching regulator provides 5 V 2 A from up to 20 V external supply.
GPIO interfaces vary widely. In some cases, they are simple—a group of pins that can switch as a group to either input or output. In others, each pin can be set up to accept or source different logic voltages, with configurable drive strengths and pull ups/downs. Input and output voltages are usually, but not always, limited to the supply ...
NodeMCU was created shortly after the ESP8266 came out. On December 30, 2013, Espressif Systems [6] began production of the ESP8266. [12] NodeMCU started on 13 Oct 2014, when Hong committed the first file of nodemcu-firmware to GitHub. [13]
For example, one PMBus operation might reconfigure three power supplies (using three different I 2 C target addresses), and their new configurations would take effect at the same time: when they receive that STOP. With only a few exceptions, neither I 2 C nor SMBus define message semantics, such as the meaning of data bytes in messages. Message ...
Different types and colors of jumpers, with two individual black jumper pins on the left for scale. In electronics and particularly computing, a jumper is a short length of conductor used to close, open or bypass part of an electronic circuit. They are typically used to set up or configure printed circuit boards, such as the motherboards of ...
EEPROM or E 2 PROM (electrically erasable programmable read-only memory) is a type of non-volatile memory. It is used in computers, usually integrated in microcontrollers such as smart cards and remote keyless systems , or as a separate chip device, to store relatively small amounts of data by allowing individual bytes to be erased and ...