Ads
related to: resistance temperature detector diagram labeled
Search results
Results From The WOW.Com Content Network
The relative change in resistance (temperature coefficient of resistance) varies only slightly over the useful range of the sensor. [ citation needed ] Platinum was proposed by Sir William Siemens as an element for a resistance temperature detector at the Bakerian lecture in 1871: [ 2 ] it is a noble metal and has the most stable resistance ...
NTC thermistors are widely used as inrush-current limiters and temperature sensors, while PTC thermistors are used as self-resetting overcurrent protectors and self-regulating heating elements. An operational temperature range of a thermistor is dependent on the probe type and is typically between −100 and 300 °C (−148 and 572 °F).
A transducer is a device that converts energy from one form to another. Usually a transducer converts a signal in one form of energy to a signal in another. [1] Transducers are often employed at the boundaries of automation, measurement, and control systems, where electrical signals are converted to and from other physical quantities (energy, force, torque, light, motion, position, etc.).
The output voltage from the thermopile, ΔV, is directly proportional to the temperature differential, ΔT or T 1 - T 2, across the thermal resistance layer and number of thermocouple junction pairs. The thermopile voltage output is also directly proportional to the heat flux, q" , through the thermal resistance layer.
The SI unit of absolute thermal resistance is kelvins per watt (K/W) or the equivalent degrees Celsius per watt (°C/W) – the two are the same since the intervals are equal: ΔT = 1 K = 1 °C. The thermal resistance of materials is of great interest to electronic engineers because most electrical components generate heat and need to be cooled.
The integrated circuit sensor may come in a variety of interfaces — analogue or digital; for digital, these could be Serial Peripheral Interface, SMBus/I 2 C or 1-Wire.. In OpenBSD, many of the I 2 C temperature sensors from the below list have been supported and are accessible through the generalised hardware sensors framework [3] since OpenBSD 3.9 (2006), [4] [5]: §6.1 which has also ...
This page was last edited on 7 September 2006, at 06:29 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may apply.
The Resistance Temperature Detector is nearly always refered to in industry as an RTD - many folk don't even know it is an acronym. Resistance thermometer is an equivalent name for the same device. Converting the two into a common reference makes good sense. These are very commonly used for industrial temperature measurements.