Ad
related to: drive cycle will not complete message on pcpchelpsoft.com has been visited by 1M+ users in the past month
Search results
Results From The WOW.Com Content Network
The "Drive-cycle" basically is the representative of the road. Drive cycles are used to reduce the expense of on road tests, time of test and fatigue of the test engineer. The whole idea is to bring the road to the test lab (a chassis dynamo-meter) or to the computer simulation. Two kinds of drive cycle can be made.
It is also known as FTP-72 or LA-4, and it is also used in Sweden as the A10 or CVS (Constant Volume Sampler) cycle and in Australia as the ADR 27 (Australian Design Rules) cycle. [4] The cycle simulates an urban route of 7.5 mi (12.07 km) with frequent stops. The maximum speed is 56.7 mph (91.2 km/h) and the average speed is 19.6 mph (31.5 km/h).
For example, the vehicle computer can identify past driving history as one particular representative cycle (say, FTP-75) and use known information from FTP-75 to improve vehicle performance. This type of control strategy is most useful for hybrid vehicles where the control strategy has a much greater effect on vehicle performance than with a ...
A modern PC with a bus rate of around 1 GHz and a 32-bit bus might be 2000x or even 5000x faster, but might have many more gigabytes of memory. With boot times more of a concern now than in the 1980s, the 30- to 60-second memory test adds undesirable delay for a benefit of confidence that is not perceived to be worth that cost by most users.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
That SFF standard described a communication protocol for an ATA host to use and control monitoring and analysis in a hard disk drive, but did not specify any particular metrics or analysis methods. Later, "S.M.A.R.T." came to be understood (though without any formal specification) to refer to a variety of specific metrics and methods and to ...
• Complete tasks. • Shop right from a message. • View travel recommendations. • Do many other actions without ever leaving your inbox. To opt-out: 1. Click the Settings icon | select More Settings. 2. Click Viewing email. 3. Toggle Dynamic message on or off. 4. Click Save.
Message Signaled Interrupts (MSI) are a method of signaling interrupts, using special in-band messages to replace traditional out-of-band signals on dedicated interrupt lines. While message signaled interrupts are more complex to implement in a device, they have some significant advantages over pin-based out-of-band interrupt signalling, such ...