Ads
related to: maytronics power supply troubleshooting guide
Search results
Results From The WOW.Com Content Network
An integrated power supply is one that shares a common printed circuit board with its load. An external power supply, AC adapter or power brick, is a power supply located in the load's AC power cord that plugs into a wall outlet; a wall wart is an external supply integrated with the outlet plug itself. These are popular in consumer electronics ...
A switched-mode power supply will be affected if the brownout voltage is lower than the minimum input voltage of the power supply. As the input voltage falls, the current draw will increase to maintain the same output voltage and current, until such a point that the power supply malfunctions or its under-voltage protection kicks in and disables ...
The ATX specification defines the Power-Good signal as a +5-volt (V) signal generated in the power supply when it has passed its internal self-tests and the outputs have stabilized. This normally takes between 0.1 and 0.5 seconds after the power supply is switched on.
In contrast, a linear power supply regulates the output voltage by continually dissipating power in the pass transistor. The switched-mode power supply's higher electrical efficiency is an important advantage. Switched-mode power supplies can also be substantially smaller and lighter than a linear supply because the transformer can be much smaller.
Overhead power lines are easiest to diagnose since the problem is usually obvious, e.g., a tree has fallen across the line, or a utility pole is broken and the conductors are lying on the ground. Locating faults in a cable system can be done either with the circuit de-energized, or in some cases, with the circuit under power.
A capacitive power supply usually has a rectifier and filter to generate a direct current from the reduced alternating voltage. Such a supply comprises a capacitor, C1 whose reactance limits the current flowing through the rectifier bridge D1. A resistor, R1, connected in series with it protects against voltage spikes during switching operations.
Low-dropout (LDO) regulators operate similarly to all linear voltage regulators.The main difference between LDO and non-LDO regulators is their schematic topology.Instead of an emitter follower topology, low-dropout regulators consist of an open collector or open drain topology, where the transistor may be easily driven into saturation with the voltages available to the regulator.
The power utility has the ability to produce 45,583 megawatts (61,128,000 hp) but could only supply 24,000 megawatts (32,000,000 hp) due to "planned and unplanned" maintenance. One turbine at Eskom's Duvha Power Station is still out of commission due to an "unexplained incident" in March 2014. [ 67 ]