Search results
Results From The WOW.Com Content Network
In the 17th century, Evangelista Torricelli conducted experiments with mercury that allowed him to measure the presence of air. He would dip a glass tube, closed at one end, into a bowl of mercury and raise the closed end out of it, keeping the open end submerged. The weight of the mercury would pull it down, leaving a partial vacuum at the far ...
Later thermionic vacuum tubes, mostly miniature style, some with top cap connections for higher voltages. A vacuum tube, electron tube, [1] [2] [3] valve (British usage), or tube (North America) [4] is a device that controls electric current flow in a high vacuum between electrodes to which an electric potential difference has been applied.
A heated metal wire (sensor wire, or simply sensor) suspended in a gas will lose heat to the gas as its molecules collide with the wire and remove heat. If the gas pressure is reduced, the number of molecules present will fall proportionately and the wire will lose heat more slowly. Measuring the heat loss is an indirect indication of pressure.
This vacuum state is called high vacuum, and the study of fluid flows in this regime is called particle gas dynamics. The MFP of air at atmospheric pressure is very short, 70 nm, but at 100 mPa (≈ 10 −3 Torr) the MFP of room temperature air is roughly 100 mm, which is on the order of everyday objects such as vacuum tubes.
Pressure measurement is the measurement of an applied force by a fluid (liquid or gas) on a surface. Pressure is typically measured in units of force per unit of surface area . Many techniques have been developed for the measurement of pressure and vacuum .
In any vacuum system, some gas will continue to escape into the chamber over time and slowly increase the pressure if it is not pumped out. [5] This leak rate is usually measured in mbar L/s or torr L/s. While some gas release is inevitable, if the leak rate is too high, it can slow down or even prevent the system from reaching low pressure.
In instructional laboratories, the Franck–Hertz experiment is often done using neon gas, which shows the onset of inelastic collisions with a visible orange glow in the vacuum tube, and which also is non-toxic, should the tube be broken. With mercury tubes, the model for elastic and inelastic collisions predicts that there should be narrow ...
Materials for use in vacuum are materials that show very low rates of outgassing in vacuum and, where applicable, are tolerant to bake-out temperatures. The requirements grow increasingly stringent with the desired degree of vacuum to be achieved in the vacuum chamber. The materials can produce gas by several mechanisms.