When.com Web Search

  1. Ad

    related to: connect dac to amplifier

Search results

  1. Results From The WOW.Com Content Network
  2. Digital-to-analog converter - Wikipedia

    en.wikipedia.org/wiki/Digital-to-analog_converter

    Switched capacitor DAC contains a parallel capacitor network. Individual capacitors are connected or disconnected with switches based on the input. The R-2R ladder DAC which is a binary-weighted DAC that uses a repeating cascaded structure of resistor values R and 2R. This improves the precision due to the relative ease of producing equal ...

  3. Analog-to-digital converter - Wikipedia

    en.wikipedia.org/wiki/Analog-to-digital_converter

    A delta-encoded or counter-ramp ADC has an up-down counter that feeds a DAC. The input signal and the DAC both go to a comparator. The comparator controls the counter. The circuit uses negative feedback from the comparator to adjust the counter until the DAC's output matches the input signal and number is read from the counter. Delta converters ...

  4. Resistor ladder - Wikipedia

    en.wikipedia.org/wiki/Resistor_ladder

    Figure 2: 4-bit linear R–2R DAC using unequal resistors. It is not necessary that each "rung" of the R–2R ladder use the same resistor values. It is only necessary that the "2R" value matches the sum of the "R" value plus the Thévenin-equivalent resistance of the lower-significance rungs. Figure 2 shows a linear 4-bit DAC with unequal ...

  5. Operational transconductance amplifier - Wikipedia

    en.wikipedia.org/wiki/Operational_trans...

    The operational transconductance amplifier (OTA) is an amplifier that outputs a current proportional to its input voltage. Thus, it is a voltage controlled current source (VCCS). Three types of OTAs are single-input single-output, differential-input single-output, and differential-input differential-output (a.k.a. fully differential), [ 1 ...

  6. Transimpedance amplifier - Wikipedia

    en.wikipedia.org/wiki/Transimpedance_amplifier

    The sensors which transimpedance amplifiers are used with usually have more capacitance than an op-amp can handle. The sensor can be modeled as a current source and a capacitor C i. [4] This capacitance across the input terminals of the op-amp, which includes the internal capacitance of the op-amp, introduces a low-pass filter in the feedback path.

  7. Delta-sigma modulation - Wikipedia

    en.wikipedia.org/wiki/Delta-sigma_modulation

    However, in general, a delta-sigma DAC converts a discrete time series signal of digital samples at a high-bitdepth into a low-bitdepth (often 1-bit) signal, usually at a much higher sampling rate. That delta-modulated signal can then be accurately converted into analog (since lower bitdepth DACs are easier to be highly-linear), which then goes ...

  8. Schiit Audio - Wikipedia

    en.wikipedia.org/wiki/Schiit_Audio

    Schiit Audio (commonly referred to as Schiit) is an American privately held audio company founded in June 2010 that specializes in the design, development, and production of various high-fidelity audio products targeted at the audiophile market, such as standalone digital-to-analog converters (DACs), headphone amplifiers, equalizers, preamplifiers, and speaker amplifiers, as well as ...

  9. Class-D amplifier - Wikipedia

    en.wikipedia.org/wiki/Class-D_amplifier

    Block diagram of a basic class-D amplifier. Note: For clarity, signal periods are not shown to scale. A class-D amplifier or switching amplifier is an electronic amplifier in which the amplifying devices (transistors, usually MOSFETs) operate as electronic switches, and not as linear gain devices as in other amplifiers.