Ads
related to: mustang maf sensor problems
Search results
Results From The WOW.Com Content Network
The hot film MAF sensor works somewhat similar to the hot wire MAF sensor, but instead it usually outputs a frequency signal. This sensor uses a hot film-grid instead of a hot wire. [3] It is commonly found in late 1980s and early 1990s fuel-injected vehicles. The output frequency is directly proportional to the air mass entering the engine.
It featured a larger MAF sensor body than the ones installed in the Australian cars, to avoid any intake restriction issues and still deliver accurate injection at all times. North American tuners (and also the Australian manufacturers & tuners Holden & HSV) of the LS1 tend to prefer retaining the MAF sensor, instead more simply overcoming ...
Ram-air intake on a Kawasaki ZX-12R. A ram-air intake is any intake design which uses the dynamic air pressure created by vehicle motion, or ram pressure, to increase the static air pressure inside of the intake manifold on an internal combustion engine, thus allowing a greater massflow through the engine and hence increasing engine power.
The same manifold was used in MAF applications, with the addition of the MAF sensor in the air intake tube. The MAF system continued, with minor revisions, until the retirement of the engine in 2001. Ford offered a performance head that was a stock part on 1993–1995 Mustang Cobra models and pre-1997 ½ Ford Explorers and Mercury Mountaineers ...
A fuel-injected engine may alternatively use a mass airflow sensor (MAF sensor) to detect the intake airflow. A typical naturally aspirated engine configuration employs one or the other, whereas forced induction engines typically use both; a MAF sensor on the Cold Air Intake leading to the turbo and a MAP sensor on the intake tract post- turbo ...
Things to Consider When Shopping for an OBD-II Scanner. In 1996, the Environmental Protection Agency made the OBD-II port mandatory in all U.S. cars.
This is due to the fact that the fuel hits the intake valves on the way to the combustion chamber, allowing the detergents in the fuel to keep them clean. However, carbon build-up on intake valves is a problem for engines with direct injection only, as the fuel is injected directly into the combustion chamber.
The IAC actuator is an electrically controlled device, which gets its input from the vehicle's engine control unit (ECU). The actuator is fitted such that it either bypasses the throttle or operates the throttle butterfly valve directly.