Search results
Results From The WOW.Com Content Network
bullet – optional – the diameter of the bullet used in the cartridge, expressed in mm or in; only include the number, and not the units of measurement, and omit any commas. land – optional – the land diameter of the rifling in the barrel, expressed in mm or in; only include the number, and not the units of measurement, and omit any commas.
While modern firearms are generally referred to by the name of the cartridge the gun is chambered for, they are still categorized together based on bore diameter. [citation needed] For example, a firearm might be described as a "30 caliber rifle", which could accommodate any of a wide range of cartridges using a roughly 0.30 inches (7.6 mm) projectile; or as a "22 rimfire", referring to any ...
The cylinder is bored straight through with no step. Later versions used an inside the case lubricated bullet of .357" diameter instead of the original .38" with a reduction in bore diameter. The difference in .38 Special bullet diameter and case diameter reflects the thickness of the case mouth (approximately 11/1000-inch per side).
bullet – optional – the diameter of the bullet used in the cartridge, expressed in mm or in; only include the number, and not the units of measurement, and omit any commas. land – optional – the land diameter of the rifling in the barrel, expressed in mm or in; only include the number, and not the units of measurement, and omit any commas.
m = bullet mass in grains (defined as 64.79891 milligrams) s = gyroscopic stability factor (dimensionless) d = bullet diameter in inches; l = bullet length in calibers (that is, length in relation to the diameter) t = twist rate in calibers per turn; Also, since one "caliber" in this context is one bullet diameter, we have:
SMc cartridges were developed in an attempt to produce an efficient cartridge combining low recoil, low heat, and high velocity. [4] The 5 mm/35 SMc has produced velocities in excess of 4,800 ft/s (1,500 m/s) shooting a 30-grain (1.9 g) molybdenum disulfide-coated Berger bullet from a 28-inch (71 cm) Pac-Nor barrel, far higher than its commercial counterpart the .204 Ruger.
A typical bullet would consist of soft lead from 150 to 250 grains in weight with a black powder appropriate lubricant in the groove(s). Gallery loads using a 0.454" diameter 141 grain lead round ball may also be suitable for some applications. Crimping the case around the round ball may be necessary to prevent ball movement during recoil.
The .221 Remington Fireball (5.7x35mm), often simply referred to as .221 Fireball, is a centerfire cartridge created by Remington Arms Company in 1963 as a special round for use in their experimental single-shot bolt-action pistol, the XP-100. [2]