Search results
Results From The WOW.Com Content Network
A CMOS transistor NAND element. V dd denotes positive voltage.. In CMOS logic, if both of the A and B inputs are high, then both the NMOS transistors (bottom half of the diagram) will conduct, neither of the PMOS transistors (top half) will conduct, and a conductive path will be established between the output and Vss (ground), bringing the output low.
The NAND gate has the property of functional completeness, which it shares with the NOR gate. That is, any other logic function (AND, OR, etc.) can be implemented using only NAND gates. [2] An entire processor can be created using NAND gates alone. In TTL ICs using multiple-emitter transistors, it also requires fewer transistors than a NOR gate.
Due to the functional completeness property of the NAND and NOR gates, a full adder can also be implemented using nine NAND gates, [4] or nine NOR gates. Using only two types of gates is convenient if the circuit is being implemented using simple integrated circuit chips which contain only one gate type per chip.
In the twelve projects included in the course, learners start with a two input Nand gate and end up with a fully operational virtual computer, including both hardware (memory and CPU) and software (assembler, VM, Java-like programming language, and OS). In addition to the hardware simulator used for initial implementation of the computer ...
As an example, consider the static logic implementation of a CMOS NAND gate: This circuit implements the logic function = ¯ If A and B are both high, the output will be pulled low. If either A or B are low, the output will be pulled high. At all times, the output is pulled either low or high.
An XNOR gate can be implemented using a NAND gate and an OR-AND-Invert gate, as shown in the following picture. [3] This is based on the identity ¯ (¯) ¯ An alternative, which is useful when inverted inputs are also available (for example from a flip-flop), uses a 2-2 AND-OR-Invert gate, shown on below on the right.
This is an important distinction to make since subtraction itself is not commutative, but the difference bit is calculated using an XOR gate which is commutative. Figure 2: Half-subtractor using NAND gate only. The truth table for the half subtractor is:
Schematic of basic two-input DTL NAND gate. R3, R4 and V− shift the positive output voltage of the input DL stage below the ground (to cut off the transistor at low input voltage). Diode–transistor logic ( DTL ) is a class of digital circuits that is the direct ancestor of transistor–transistor logic .