Search results
Results From The WOW.Com Content Network
Data communication, including data transmission and data reception, is the transfer of data, transmitted and received over a point-to-point or point-to-multipoint communication channel. Examples of such channels are copper wires , optical fibers , wireless communication using radio spectrum , storage media and computer buses .
Data in the header is used by networking hardware to direct the packet to its destination, where the payload is extracted and used by an operating system, application software, or higher layer protocols. Packet switching is the primary basis for data communications in computer networks worldwide.
AS-i – Actuator-sensor interface, a low level 2-wire bus establishing power and communications to basic digital and analog devices; BSAP – Bristol Standard Asynchronous Protocol, developed by Bristol Babcock Inc. CC-Link Industrial Networks – Supported by the CLPA
A data link is a means of connecting one location to another for the purpose of transmitting and receiving digital information (data communication). It can also refer to a set of electronics assemblies, consisting of a transmitter and a receiver (two pieces of data terminal equipment ) and the interconnecting data telecommunication circuit .
The Shannon–Weaver model is one of the first models of communication. Initially published in the 1948 paper "A Mathematical Theory of Communication", it explains communication in terms of five basic components: a source, a transmitter, a channel, a receiver, and a destination. The source produces the original message.
The presentation layer may provide the following services to the application layer: a request for the establishment of a session, data transfer, negotiation of the syntax to be used between the application layers, any necessary syntax transformations, formatting and special purpose transformations (e.g., data compression and data encryption). [78]
Part 5 provides a communication profile for sending basic telecontrol messages between two systems, which uses permanent directly connected data circuits between the systems. The IEC Technical Committee 57 (Working Group 03) have developed a protocol standard for telecontrol, teleprotection, and associated telecommunications for electric power ...
The basic function of the Profinet is the cyclic data exchange between the IO-Controller as producer and several IO-Devices as consumers of the output data and the IO-Devices as producers and the IO-Controller as consumer of the input data. [1] Each communication relationship IO data CR between the IO-Controller and an IO-Device defines the ...