Ads
related to: best angle for joist hangers
Search results
Results From The WOW.Com Content Network
Although the use of steel joist hangers to support floor joists is recommended over a ledger supporting the joists because of house settling and nail separation, they are not required by code in most municipalities. However, toe nailing & end nailing is nowhere near as effective as using hangers to support flooring systems. [7]
This page was last edited on 15 May 2018, at 20:51 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may apply ...
A double floor is a floor framed with joists supported by larger timbers.. In traditional timber framing there may be a single set of joists which carry both a floor and ceiling called a single floor (single joist floor, single framed floor) or two sets of joists, one carrying the floor and another carrying the ceiling called a double floor (double framed floor).
The CJ-Series Joists are capable of supporting larger floor or roof loadings due to the attachment of the concrete slab to the top chord of the composite joist. Shear connection between the concrete slab and steel joist is typically made by the welding of shear studs through the steel deck to the underlying CJ-Series Composite Steel Joist. [2]
The rim joist depth must match the I-joist size. Mismatches can strain the joist. A similar situation occurs where the I-joist crosses a main beam. Installing squash blocks (2×4 materials 1 ⁄ 16 in or 1.6 mm higher than the I-joist) alongside the I-joists transfers the load from the I-joist onto the beam. Missed nails and glue setting too ...
Joist hanger nail – special nails rated for use with joist hangers and similar brackets. Sometimes called "Teco nails" (1 + 1 ⁄ 2 × .148 shank nails used in metal connectors such as hurricane ties) Lost-head nail – see finish nail; Masonry (concrete) – lengthwise fluted, hardened nail for use in concrete
In machining, the rake angle is a parameter used in various cutting processes, describing the angle of the cutting face relative to the workpiece. There are three types of rake angles: positive, zero or neutral, and negative. Positive rake: A tool has a positive rake when the face of the cutting tool slopes away from the cutting edge at inner side.
Approach (α) and departure angle (β) of a vehicle. Approach angle is the maximum angle of a ramp onto which a vehicle can climb from a horizontal plane without interference. [1] It is defined as the angle between the ground and the line drawn between the front tire and the lowest-hanging part of the vehicle at the front overhang.