Ads
related to: should bios be set to ahci display device driver
Search results
Results From The WOW.Com Content Network
Some operating systems, notably Windows Vista, Windows 7, Windows 8, Windows 8.1 and Windows 10, do not configure themselves to load the AHCI driver upon boot if the SATA controller was not in AHCI mode at the time the operating system was installed. Although this is an easily rectifiable condition, it remains an ongoing issue with the AHCI ...
The Intel RAID ROM is the firmware in the motherboard BIOS that is used to create the RAID array. Note: The RST drivers can be used for RAID and also on a single drive as it contains an AHCI driver. There is a bug in the version 12.5.0.1066 RST driver, which cause TRIM commands not to pass through the RAID driver to the drives.
Prior to the development and ubiquitous adoption of the Plug and Play BIOS standard, an add-on device such as a hard disk controller or a network adapter card (NIC) was generally required to include an option ROM in order to be bootable, as the motherboard BIOS did not include any support for the device and so could not incorporate it into the BIOS's boot protocol.
The problem is you get a board that came set up for IDE mode or you set it to IDE mode to avoid the need to use a floppy or slipstream or to use an older linux distro or whatever. Then sometime later you come to add a hard drive or or optical drive and find that half your disk controller ports are unusable without switching to ahci mode.
Device Sleep with a maximum return latency of 20 milliseconds unless otherwise specified in Identify Data Log; These can be selected by the SATA AHCI driver, usually via a configuration option, or by the OS Power Options. Windows Vista and later allows the tweaking of AHCI LPM modes through a registry hack. [3] Hot swapping is disabled.
Open Host Controller Interface (OHCI) [1] is an open standard.. Die shot of a VIA VT6307 Integrated Host Controller used for IEEE 1394A communication. When applied to an IEEE 1394 (also known as FireWire; i.LINK or Lynx) card, OHCI means that the card supports a standard interface to the PC and can be used by the OHCI IEEE 1394 drivers that come with all modern operating systems.
INT 10h is fairly slow, so many programs bypass this BIOS routine and access the display hardware directly. Setting the video mode, which is done infrequently, can be accomplished by using the BIOS, while drawing graphics on the screen in a game needs to be done quickly, so direct access to video RAM is more appropriate than making a BIOS call ...
ICH - 82801AA. The first version of the ICH was released in June 1999 along with the Intel 810 northbridge.While its predecessor, the PIIX, was connected to the northbridge through an internal PCI bus with a bandwidth of 133 MB/s, the ICH used a proprietary interface (called by Intel Hub Interface) that linked it to the northbridge through an 8-bit wide, 266 MB/s bus.