Ads
related to: tire plugs for large holes in gravel ground anchors outdoor metal- Clearance Sale
Enjoy Wholesale Prices
Find Everything You Need
- Where To Buy
Daily must-haves
Special for you
- Store Locator
Team up, price down
Highly rated, low price
- Women's Clothing
Limited time offer
Hot selling items
- Today's hottest deals
Up To 90% Off For Everything
Countless Choices For Low Prices
- Best Seller
Countless Choices For Low Prices
Up To 90% Off For Everything
- Clearance Sale
Search results
Results From The WOW.Com Content Network
The magnitude of total anchor force required in the tieback can be determined by analyzing the soil and groundwater properties as well as sources of external loads applied to the system. [ 2 ] The bond length of the tieback must extend beyond the potential critical failure surface of the soil.
Single helix earth anchors Guyed mast anchor. An earth anchor is a device designed to support structures, most commonly used in geotechnical and construction applications. Also known as a ground anchor, percussion driven earth anchor or mechanical anchor, it may be impact driven into the ground or run in spirally, depending on its design and intended force-resistance characteristics.
Helical anchors consist of an extendable steel shaft with helical bearing plates. Piles or piers refer to strong base elements that withstand or transfer vertical/horizontal loads. Anchors are piles utilised only in tension applications like restraining wall tiebacks or vertical ground anchors made to resist overturning forces.
A deep-penetrating anchor (DPA) is conceptually similar to a torpedo anchor: it features a dart-shaped, thick-walled, steel cylinder with flukes attached to the upper section of the anchor. A full-scale DPA is approximately 15 metres (49 ft) in length, 1.2 metres (4 ft) in diameter, and weighs on the order of 50–100 tonnes (49–98 long tons ...
1960s-era pitons, including: knifeblades, lost arrows, bugaboos, ring angles, and bongs. A piton (/ ˈ p iː t ɒ n /; also called pin or peg) in big wall climbing and in aid climbing is a metal spike (usually steel) that is driven into a crack or seam in the climbing surface using a climbing hammer, and which acts as an anchor for protecting the climber from falling or to assist progress in ...
Before commercial wall plugs, fixings were made to brick or masonry walls by first chiselling a groove into a soft mortar joint, hammering in a crude wooden plug and then attaching to the wooden plug. This was time consuming and required a large hole, thus more patching of the wall afterwards. It also limited the holes' location to the mortar ...