Ads
related to: what does a tachometer measure weight gain rate formula for small oil wells
Search results
Results From The WOW.Com Content Network
Production tests involve flowing the well at different rates and measuring the flow rates and pressures. –Buildup tests: Buildup tests are conducted on producing wells to measure reservoir pressure and permeability. Builtup tests involve shutting in the well after a production test and measuring the pressure as it builds back up. [7]
Drill stem testing is an oil and gas exploration procedure to isolate, stimulate and flow a downhole formation to determine the fluids present and the rate at which they can be produced. The main objective of a DST is to evaluate the commercial viability of a zone's economic potential by identifying productive capacity, pressure, permeability ...
Measurement while drilling can be cost-effective in exploration wells, particularly in areas of the Gulf of Mexico where wells are drilled in areas of salt diapirs. The resistivity log will detect penetration into salt, and early detection prevents salt damage to bentonite drilling mud. [citation needed]
Primary oil well control is the process which maintains a hydrostatic pressure in the wellbore greater than the pressure of the fluids in the formation being drilled, but less than formation fracture pressure. It uses the mud weight to provide sufficient pressure to prevent an influx of formation fluid into the wellbore. If hydrostatic pressure ...
Fluids exert pressure, and this pressure comes from the density and height of the fluid column. Oil companies typically measure density in pounds per gallon (ppg) or kilograms per cubic meter (kg/m 3) and pressure measurement in pounds per square inch (psi) or bar or pascal (Pa). Pressure increases with fluid density.
Logging while drilling (LWD) is a technique of conveying well logging tools into the well borehole downhole as part of the bottom hole assembly (BHA).. Although the terms Measurement while drilling (MWD) and LWD are related, within the context of this section, the term MWD refers to directional-drilling measurements, e.g., for decision support for the smooth operation of the drilling, while ...
Tracers are used in the oil industry in order to qualitatively or quantitatively gauge how fluid flows through the reservoir, [1] as well as being a useful tool for estimating residual oil saturation. Tracers can be used in either interwell tests or single well tests. [2]
The most common use of these radiotracers is at the well head for the measurement of flow rate for various purposes. A 1995 study found that radioactive tracers were used in over 15% of stimulated oil and gas wells. [2] Use of these radioactive tracers is strictly controlled.