Search results
Results From The WOW.Com Content Network
Surfaces with low surface energies may undergo corona or flame treatment in order to raise its surface energy. [15] However even if a surface has high energy, contaminants on the surface can interfere with the adhesive's ability to bond to the surface. The presence of contaminants such as dust, paper, and oils will reduce the contact area for ...
Some removable adhesives are designed to repeatedly stick and unstick. They have low adhesion and generally cannot support much weight. Sometimes clean removal of pressure sensitive tape can be difficult without damaging the substrate that it is adhered to. Pulling at a slow rate and with a low angle of peel helps reduce surface damage.
In the paint and coating industries, paint adhesion testing is often used to determine if the paint or coating will adhere properly to the substrates to which they are applied. Several tests measure the resistance of paints and coatings from substrates: cross-cut test, scrape adhesion, pull-off test , and others.
Likewise, contaminants, especially those which, due to their low surface tension, counteract wetting by the adhesive (for example, oils, release agents, etc.) hinder the adhesion interaction. Contaminants form, as it were, a barrier between the adhesive and the substrate which cannot be bridged by the adhesion forces due to their short reach.
To incorporate the effect of adhesion in Hertzian contact, Johnson, Kendall, and Roberts [5] formulated the JKR theory of adhesive contact using a balance between the stored elastic energy and the loss in surface energy. The JKR model considers the effect of contact pressure and adhesion only inside the area of contact.
In adhesion tests per ASTM D4541, in which an aluminum stud is bonded to the test surface and the stud is pulled in the direction normal to the surface, both surfaces of the failure interface were analyzed by X-ray photoelectron spectroscopy (XPS). F/C ratio was used as an indicator of the failure mode: F/C of zero corresponds to failure in the ...
For a peel ply, a thin, woven piece of material is applied to the adherend during fabrication. [9] Because the material is woven, it will leave a torturous surface when removed, which will improve bonding by mechanical interlocking. [6] Prior to adhesive bonding, the woven material acts to protect the surface of the adherend from contaminates.
Surface modification is the act of modifying the surface of a material by bringing physical, chemical or biological characteristics different from the ones originally found on the surface of a material. [1] This modification is usually made to solid materials, but it is possible to find examples of the modification to the surface of specific ...