Ads
related to: image of 12 inch ruler
Search results
Results From The WOW.Com Content Network
A scale ruler is a tool for measuring lengths and transferring measurements at a fixed ratio of length; two common examples are an architect's scale and engineer's scale.In scientific and engineering terminology, a device to measure linear distance and create proportional linear measurements is called a scale.
A variety of rulers A carpenter's rule Retractable flexible rule or tape measure A closeup of a steel ruler A ruler in combination with a letter scale. A ruler, sometimes called a rule, scale or a line gauge or metre/meter stick, is an instrument used to make length measurements, whereby a length is read from a series of markings called "rules" along an edge of the device. [1]
The width of the slide rule is quoted in terms of the nominal width of the scales. Scales on the most common "10-inch" models are actually 25 cm, as they were made to metric standards, though some rules offer slightly extended scales to simplify manipulation when a result overflows. Pocket rules are typically 5 inches (12 cm).
See P and DI scales in detail image. In slide rule terminology, "folded" means a scale that starts and finishes at values offset from a power of 10 . Often folded scales start at π but may be extended lengthways to, say, 3.0 and 35.0.
A typical English sector, probably from the early 19th century, made of ivory with a brass hinge. This side has scales for lines of lines (L), secants (S), chords (C), and polygons (POL), along with a scale of 10ths of inches on the outer edges forming a straight 12-inch rule when the sector is fully opened, and a scale of 100ths of a foot marked along the side (only barely visible in this ...
A sewing gauge is a ruler, typically 6 inches long, used for measuring short spaces. It is typically a metal scale, marked in both inches and centimeters with a sliding pointer, similar in use to a caliper. It is used to mark hems for alterations as well as intervals between pleats and buttonholes and buttonhole lengths. It can be also used as ...
Many US tapes also have special markings every 16 inches (406 mm), which is a US standard interval for studs in construction: three spaces of 16 inches make exactly 4 feet (1,219 mm) which is the US commercial width of a sheet of plywood, gyproc or particle board. A dual scale inch/centimeter tape measure.
Two wooden yardsticks with brass ends, in inches and division of yard for half, quarter, eighth and sixteenth A folding metre-stick carpenter's ruler with millimetre divisions and numbers in centimetres. Fully extended it measures 2 metres. In countries in which the metric system is used, the scale typically contains only a metric scale.