Search results
Results From The WOW.Com Content Network
While in principle aspheric surfaces can take a wide variety of forms, aspheric lenses are often designed with surfaces of the form = (+ (+)) + + +, [3]where the optic axis is presumed to lie in the z direction, and () is the sag—the z-component of the displacement of the surface from the vertex, at distance from the axis.
If the vertex lies to the left of the center of curvature, the radius of curvature is positive. If the vertex lies to the right of the center of curvature, the radius of curvature is negative. Thus when viewing a biconvex lens from the side, the left surface radius of curvature is positive, and the right radius of curvature is negative.
Deep blue ray refers the radius of curvature and the red line segment is the sagitta of the curve (black). In optics and especially telescope making, sagitta or sag is a measure of the glass removed to yield an optical curve. It is approximated by the formula (),
The complex beam parameter is usually used in ray transfer matrix analysis, which allows the calculation of the beam properties at any given point as it propagates through an optical system, if the ray matrix and the initial complex beam parameter is known.
Base curve radius (BCR) or simply base curve (BC) is the measure of an important parameter of a lens in optometry. On a spectacle lens, it is the flatter curvature of the front surface. On a contact lens it is the curvature of the back surface and is sometimes referred to as the back central optic radius (BCOR). Typical values for a contact ...
In lens systems, aberrations can be minimized using combinations of convex and concave lenses, or by using aspheric lenses or aplanatic lenses. Lens systems with aberration correction are usually designed by numerical ray tracing. For simple designs, one can sometimes analytically calculate parameters that minimize spherical aberration.
Optical lens design is the process of designing a lens to meet a set of performance requirements and constraints, including cost and manufacturing limitations. Parameters include surface profile types (spherical, aspheric, holographic, diffractive, etc.), as well as radius of curvature, distance to the next surface, material type and optionally tilt and decenter.
The equation for a conic section with apex at the origin and tangent to the y axis is + (+) = alternately = + (+) where R is the radius of curvature at x = 0. This formulation is used in geometric optics to specify oblate elliptical ( K > 0 ), spherical ( K = 0 ), prolate elliptical ( 0 > K > −1 ), parabolic ( K = −1 ), and hyperbolic ( K ...