Search results
Results From The WOW.Com Content Network
Setup time is the minimum amount of time the data input should be held steady before the clock event, so that the data is reliably sampled by the clock. Hold time is the minimum amount of time the data input should be held steady after the clock event, so that the data is reliably sampled by the clock. Aperture is the sum of setup and hold time ...
Hold time may refer to: In digital electronics, the minimum amount of time the data input should be held steady after the clock event for reliable sampling; see Flip-flop (electronics)#Timing considerations; The amount of time spent in a phone queue on hold (telephone) Hold Time, by M. Ward
Here, the contamination delay is the amount of time needed for a change in the flip-flop clock input to result in the initial change at the flip-flop output (Q). If there is insufficient delay from the output of the first flip-flop to the input of the second, the input may change before the hold time has passed. Because the second flip-flop is ...
There are two types of violation that can be caused by clock skew. One problem is caused when the clock reaches the first register and the clock signal towards the second register travels slower than output of the first register into the second register - the output of the first register reaches the second register input faster and therefore is clocked replacing the initial data on the second ...
The attack control is used to define the length of time the gate takes to change from closed to fully open. It is the fade-in duration. The hold control is used to define the length of time the gate will stay fully open after the signal falls below the threshold, and before the release period is commenced. The hold control is often set to ...
Shortcut Action; Navigate to the left tab [Navigate to the right tab ] Start a new email conversation N: Go to the inbox M: Go to Settings ; Search
A simple example of metastability can be found in an SR NOR latch, when both Set and Reset inputs are true (R=1 and S=1) and then both transition to false (R=0 and S=0) at about the same time. Both outputs Q and Q are initially held at 0 by the simultaneous Set and Reset inputs.
This requires the PCB to be designed to add a 1.5–2 ns delay to the clock signal to meet the setup and hold times on the sink. RGMII v2.0 specifies an optional internal delay, obviating the need for the PCB designer to add delay; this is known as RGMII-ID.