Search results
Results From The WOW.Com Content Network
1984-1997 Jeep Wagoneer; 1984-2001 Jeep Cherokee; 1993-2004 Jeep Grand Cherokee; 1986-1992 Jeep Comanche; 1987-1995 Jeep YJ Wrangler Note: there was no 96 model. 1997-2006 Jeep TJ Wrangler *option Dana 44 rear and Rubicon's had Dana 44's; 2007 only some early Jeep JK 2 door Wranglers had Dana 35 non c-clip axles. 2001-2007 Jeep Liberty; Dodge ...
The third digit indicates differential type: 1 means locked (no differential), 2 means open, 3 means electric locked, 4 and 5 both indicate an asymmetrical torque split planetary gear and gear drive, 6 means an electronic clutch pack, 7 means a hydraulic clutch pack (except for the unique 207), and 9 means a viscous coupler.
Download as PDF; Printable version; ... 2011 Jeep Dana 30 differential Jeep Dana 30. General specifications. Ring Gear measures 7.12 inches (181 mm)
The Jeep Cherokee (XJ) is a sport utility vehicle manufactured and marketed across a single generation by Jeep in the United States from 1983 (model year 1984) through 2001 — and globally through 2014. It was available in two- or four-door, five-passenger, front-engine, rear- or four-wheel drive configurations.
The 10.5" 14-bolt differential and axle is quite popular with Jeep Wrangler owners who want to upgrade their standard Dana 30, Dana 35, or Dana 44 axle. While the 10.5" 14-bolt axle is heavier than the standard Dana axles offered on the Wrangler, it is much stronger.
The 45RFE was introduced in the Jeep Grand Cherokee in 1999, it is notable for including three planetary gearsets rather than the two normally used in a 4-speed automatic. It also features three multiple disc input clutches, three multiple disc holding clutches, and a dual internal filter system (one primary filter for transmission sump, one for the fluid cooler return system).
It was typically used in the back of jeep JKs, Isuzus and Nissan pickups. This ring and pinion does share some components and can be adapted into an earlier Dana 44 but requires some work, different bearings and spacers. The benefit is the larger ring gear, better angle cut on the teeth and Dana 60 diameter pinion shaft.
The Dana 70 axle only came with 5.13:1, 4.88,5.31 [citation needed] gear ratios and had a GAWR of [citation needed] these axles were rated at 7-9klbs as seen on 5500 door stickers. They differ greatly from previous Dana 70 front axles, some of the major differences being the use of 1550 Universal Joints and being a high pinion, reverse cut axle.