Search results
Results From The WOW.Com Content Network
Standard rate turn is a standardized rate at which the aircraft will make a 360 degree turn in two minutes (120 seconds). Standard rate turn is indicated on turn coordinator or turn-slip indicator. All turns during flights under instrument rules shall be made at standard turn rate, but no more than 30 degrees of bank.
The position of all three axes, with the right-hand rule for describing the angle of its rotations. An aircraft in flight is free to rotate in three dimensions: yaw, nose left or right about an axis running up and down; pitch, nose up or down about an axis running from wing to wing; and roll, rotation about an axis running from nose to tail.
An aircraft moves at any given moment in one or more of three axes: roll (the axis that runs the length of the fuselage), pitch (the axis running laterally through the wings), and yaw (the vertical axis around which the front of the aircraft turns to the left or right whilst its rear turns toward the opposite direction).
The body x-axis does not align with the velocity vector, which is the reference direction for wind axes. In other words, wind axes are not principal axes (the mass is not distributed symmetrically about the yaw and roll axes). Consider the motion of an element of mass in position -z, x in the direction of the y-axis, i.e. into the plane of the ...
Unlike turning a boat, changing the direction of an aircraft normally must be done with the ailerons rather than the rudder. The rudder turns (yaws) the aircraft but has little effect on its direction of travel. With aircraft, the change in direction is caused by the horizontal component of lift, acting on the wings.
However, in aviation, a clock position refers to a horizontal direction. The pilots needed a vertical dimension, so they supplemented the clock position with the word high or low to describe the vertical direction; e.g., 6 o'clock high means behind and above the horizon, while 12 o'clock low means ahead and below the horizon. [5]
Image showing the face of a turn coordinator during a standard rate coordinated right turn. The turn coordinator (TC) is a further development of the turn and slip indicator (T/S) with the major difference being the display and the axis upon which the gimbal is mounted. The display is that of a miniature airplane as seen from behind.
A standard rate turn is defined as a 3° per second turn, which completes a 360° turn in 2 minutes. This is known as a 2-minute turn, or rate one (180°/min). Fast airplanes, or aircraft on certain precision approaches, use a half standard rate ('rate half' in some countries), but the definition of standard rate does not change.