When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Reamer - Wikipedia

   en.wikipedia.org/wiki/Reamer

   A tapered reamer may be used for cleaning burrs from a drilled hole, or to enlarge a hole. The body of the tool tapers to a point. This type of reamer consists of a body which, typically, is up to 1/2 inch in diameter, with a rod cross piece at the large end acting to form a handle.

3. Directional boring - Wikipedia

   en.wikipedia.org/wiki/Directional_boring

   Directional boring machine. Directional boring, also referred to as horizontal directional drilling (HDD), is a minimal impact trenchless method of installing underground utilities such as pipe, conduit, or cables in a relatively shallow arc or radius along a prescribed underground path using a surface-launched drilling rig.

4. Pipe tool - Wikipedia

   en.wikipedia.org/wiki/Pipe_tool

   Most common is the three-in-one Czech tool, which consists of a tamper, reamer and pick joined together. A pipe knife is another three-in-one tool: the reamer and pick fold into the casing in the same fashion as a pocketknife, while the blunt end is used as a tamper. A pipe nail is a nail-shaped tool with a tamper at one end and a reamer at the ...

5. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   Used almost exclusively for deep hole drilling of medium to large diameter holes (approximately 3 ⁄ 4 –4 in or 19–102 mm diameter). An ejector drill bit uses a specially designed carbide cutter at the point. The bit body is essentially a tube within a tube. Flushing water travels down between the two tubes.

6. Pipecutter - Wikipedia

   en.wikipedia.org/wiki/Pipecutter

   Pipecutter Cutting copper pipe with a close quarters tubing cutter. A pipecutter is a type of tool used to cut pipe. Depending on the metal of the pipe, a pipecutter can often provide a faster, cleaner and more convenient way of cutting pipe than using a hacksaw. There are two types of pipe cutters.

7. Underreamer - Wikipedia

   en.wikipedia.org/wiki/Underreamer

   Compact block-type PDC underreamer (Drillstar Z-Reamer) An underreamer is a device used to enlarge the borehole below an existing casing or restriction, during a well drilling operation. It can be positioned either above the drill bit or above a pilot assembly run inside the existing borehole.