Search results
Results From The WOW.Com Content Network
A supplemental chamber or cartridge adapter is typically used for a shorter cartridge of reduced diameter. [1] A cartridge conversion sleeve may include a short barrel of reduced bore diameter. Shotgun conversion sleeves may be called subgauge inserts , subgauge tubes , or gauge reducers .
The shank length is not always the same at the thread length, which is the case if the insert has a threadless portion (sub-shank) Tenon designates the thread length; Shoulder designates the barrel diameter in front of the thread portion; Unless otherwise mentioned, right hand threads are assumed. Left hand threads are designated "LH".
Original USAF M6 survival rifle/shotgun, caliber .22 Hornet/.410 shotgun. The M6 aircrew survival weapon was made for the US Air Force, with a .22 Hornet rifle barrel mounted over a .410 bore shotgun barrel and was first issued in the Korean War. The military also lists an aluminum .410 3-inch (76 mm) shell, with a rifle primer, as standard ...
Light tank Mk VII Tetrarch Mk I with Littlejohn adaptor.. The Littlejohn adaptor was a device that could be added to the British QF 2 pounder (40 mm) anti-tank gun. It was used to extend the service life of the 2-pounder during the Second World War by converting it to squeeze bore operation.
Available in 20 gauge or .410 Bore/.45 Colt only. Available in either a blued finish or an electroless nickel finish with a polymer stock has a thumbhole/pistol-grip design. The right side of the stock is open with storage for three 20 gauge or four .410 bore shotgun shells. Topper shotgun (Single-shot). Available in gauges 12, 16, 20, and in ...
The M26-MASS (Modular Accessory Shotgun System) is a shotgun configured as an underbarrel ancillary weapon attachment mounted onto the handguard of a service rifle, usually the M16/M4 family of United States military, essentially making the host weapon a combination gun.
In firearms, the forearm (also known as the fore-end/forend, handguard or forestock) is a section of a gunstock between the receiver and the muzzle. It is used as a gripping surface to hold the gun steady and is usually made out of heat-insulating material such as wood or reinforced plastic .
Charging handle being pulled on an M2 machine gun. The cocking handle, also known as charging handle or bolt handle, is a device on a firearm which, when manipulated, results in the bolt being pulled to the rear, putting the hammer/striker into a spring-loaded ("cocked") "ready and set" position, allowing the operator to open the breech and eject any spent/unwanted cartridge/shell from the ...