Search results
Results From The WOW.Com Content Network
A selection of conical coil springs. Spring rate is the measurement of how much a coil spring can hold until it compresses 1 inch (2.54 cm). The spring rate is normally specified by the manufacture. If a spring has a rate of 100 then the spring would compress 1 inch with 100 pounds (45 kg) of load. [1]
A torsion spring's rate is in units of torque divided by angle, such as N·m/rad or ft·lbf/degree. The inverse of spring rate is compliance, that is: if a spring has a rate of 10 N/mm, it has a compliance of 0.1 mm/N. The stiffness (or rate) of springs in parallel is additive, as is the compliance of springs in series.
The arc spring (also known as - bow spring, curved spring, circular spring or "banana" spring) is a special form of coil spring which was originally developed for use in the dual-mass flywheel of internal combustion engine drive trains. The term "arc spring" is used to describe pre-curved or arc-shaped helical compression springs.
A tandem rolling mill is a rolling mill used to produce wire and sheet metal. It is composed of two or more close-coupled [clarification needed] stands, and uses tension between the stands as well as compressive force from work rolls [clarification needed] to reduce the thickness of steel. It was first patented by Richard Ford in 1766 in England.
Coiled spring pin. A coiled spring pin, also known as a spiral pin, is a self retaining engineered fastener manufactured by roll forming metal strip into a spiral cross section of 2 + 1 ⁄ 4 coils. Coiled spring pins have a body diameter larger than the recommended hole diameter and chamfers on both ends to facilitate starting the pin into the ...
The amount of deformation possible in a single pass is limited by the friction between the rolls; if the change in thickness is too great the rolls just slip over the material and do not draw it in. [1] The final product is either sheet or plate, with the former being less than 6 mm (0.24 in) thick and the latter greater than; however, heavy ...
The mill stand can be work roll driven or back up roll driven. The mill can be designed with hydraulic work roll bending or back up roll bending. Installations typically have a single rolling mill stand, but may have two. Pinch rolls provide back tension for the pay off reel in the entry section and entry and exit tension for the temper pass.
A coil of wire attached to the pointer twists in a magnetic field against the resistance of a torsion spring. Hooke's law ensures that the angle of the pointer is proportional to the current. A DMD or digital micromirror device chip is at the heart of many video projectors .