Search results
Results From The WOW.Com Content Network
A hydrostatic test involves pressurising the cylinder to its test pressure (usually 5/3 or 3/2 of the working pressure) and measuring its volume before and after the test. A permanent increase in volume above the tolerated level means the cylinder fails the test and must be permanently removed from service. [3]: sect. 5.7.3
A hydrostatic test is a way in which pressure vessels such as pipelines, plumbing, gas cylinders, boilers and fuel tanks can be tested for strength and leaks. The test involves filling the vessel or pipe system with a liquid, usually water, which may be dyed to aid in visual leak detection , and pressurization of the vessel to the specified ...
The most common test involves measuring the flow of water flowing out of a municipal fire hydrant (measured in litres or gallons per minute) while recording how much the water pressure has dropped (from no water flow to test flow). When the results are collected carefully, formulas can be applied to figure the varying pressure(s) that will be ...
Activated sludge tank at Beckton sewage treatment plant, UK.The white bubbles are due to the diffused air aeration system. The activated sludge process is a type of biological wastewater treatment process for treating sewage or industrial wastewaters using aeration and a biological floc composed of bacteria and protozoa.
Mixed liquor suspended solids (MLSS) is the concentration of suspended solids, in an aeration tank during the activated sludge process, which occurs during the treatment of waste water. The units MLSS is primarily measured in milligram per litre (mg/L), but for activated sludge its mostly measured in gram per litre [g/L] which is equal to ...
A percolation test (colloquially called a perc test) is a test to determine the water absorption rate of soil (that is, its capacity for percolation) in preparation for the building of a septic drain field (leach field) or infiltration basin. [1] The results of a percolation test are required to design a septic system properly.
The compressor and particularly the compressor oil, must be suitable for this service. If the oxygen fraction is less than 40%, some countries do not require the cylinder and valve to be cleaned for oxygen service. Mixing by mass fraction: oxygen is added to a partially full cylinder that is accurately weighed until the required mix is achieved.
It is similar to the Hazen color test, to which it is sometimes incorrectly referred. The Hazen color test uses a Pt/Co solution and was developed for water treatment facilities where the Color of water could be used as a measure of concentration of dissolved and particulate material. Slight discoloration is measured in Hazen units (HU). [3]