Ads
related to: 4l60e transmission dipstick tube seal set up procedure
Search results
Results From The WOW.Com Content Network
An updated 4L60E, the 4L65E (RPO M32), was phased in the 2001 model year when coupled behind the 6.0 Vortec. Five-pinion front and rear planetaries, along with an additional 3/4 clutch allowing 7 clutches in the input housing and induction hardened input shaft assembly, were improved to withstand up to 380 ft⋅lb (520 N⋅m) of torque.
In 1996, GM introduced a redesigned 4L60E transmission case that incorporated a bolt-on bellhousing and a six-bolt tail housing. This two-piece case style was first seen in 1996 and up model S-10 Blazer, S-10 pickup, GMC Jimmy, and GMC Sonoma with the 4.3 L engine. The majority of 1998 and later applications of the 4L60E were two-piece cases (i ...
The Dipstick Tube. Any transmission with a dipstick tube has the potential to let additional oxygen into the transmission through a dipstick that is not fully seated in the tube or a dipstick tube plug that is not fully seated. Even the process of checking the fluid level with a dipstick can allow additional oxygen and dirt to be transmitted.
For 1991 GM introduced the 4T60-E which was a 4T60 with electronic controls, first seen on the new Buick Park Avenue.One benefit was that the cruise control was integrated into the gearbox' electronic control module, improving the ability to maintain a set speed while avoiding needless shifting, thus lowering fuel consumption and noise levels. [1]
The 4L30-E was an automatic transmission developed and produced by General Motors. It was developed for light-duty use in longitudinal engine rear-wheel drive vehicles, replacing the similar TH180/3L30 .
The torque tube consists of a large diameter stationary housing between the transmission and rear end that fully encloses a rotating tubular steel or small-diameter solid drive shaft (known colloquially in the U.S. as a "rope drive" [1]) that transmits the power of the engine to a regular or limited-slip differential. [2]
Break-in or breaking in, also known as run-in or running in, is the procedure of conditioning a new piece of equipment by giving it an initial period of running, usually under light load, but sometimes under heavy load or normal load. It is generally a process of moving parts wearing against each other to produce the last small bit of size and ...
Radial shaft seals, also known as lip seals, are used to seal rotary elements, such as a shaft or rotating bore. Common examples include strut seals, hydraulic pump seals, axle seals, power steering seals, and valve stem seals.