Ad
related to: calculate acres from lot size
Search results
Results From The WOW.Com Content Network
One acre equals 1 ⁄ 640 (0.0015625) square mile, 4,840 square yards, 43,560 square feet, [2] or about 4,047 square metres (0.4047 hectares) (see below).While all modern variants of the acre contain 4,840 square yards, there are alternative definitions of a yard, so the exact size of an acre depends upon the particular yard on which it is based.
A lot has defined boundaries (or borders) which are documented somewhere, but the boundaries need not be shown on the land itself. Most lots are small enough to be mapped as if they are flat, in spite of the curvature of the Earth. A characteristic of the size of a lot is its area. The area is typically determined as if the land is flat and ...
One of the reasons for creating sections of 640 acres (260 ha) was the ease of dividing into halves and quarters while still maintaining a whole number of acres. A section can be halved seven times in this way, down to a 5-acre (2 ha) parcel, or half of a quarter-quarter-quarter section—an easily surveyed 50-square-chain (2 ha) area. This ...
As the name suggests, an acre-foot is defined as the volume of one acre of surface area to a depth of one foot.. Since an acre is defined as a chain by a furlong (i.e. 66 ft × 660 ft or 20.12 m × 201.17 m), an acre-foot is 43,560 cubic feet (1,233.5 m 3).
The acre is also commonly used to measure land areas, where 1 acre = 4,840 square yards = 43,560 square feet. An acre is approximately 40% of a hectare. On the atomic scale, area is measured in units of barns, such that: [13] 1 barn = 10 −28 square meters. The barn is commonly used in describing the cross-sectional area of interaction in ...
In the original Homestead Act of 1862, during the Lincoln administration, each settler was allocated 160 acres (0.65 km 2) of land, a quarter-section. Later amendments of the Homestead Act allocated more land, as much as 640 acres (2.6 km 2), a section. This was a good revision to apply to land that was drier or more desolate than the earlier ...
Build-out applies land use or zoning assumptions about density to the available land area. The build-out calculation may deduct land due to physical constraints to development (e.g. sensitive natural resources), potential infrastructure dedications (e.g. streets, public open space, or stormwater management structures), and practical design considerations (e.g. lot layout inefficiencies).
The lot and block survey system is a method used in the United States and Canada to locate and identify land, particularly for lots in densely populated metropolitan areas, suburban areas and exurbs. It is sometimes referred to as the recorded plat survey system or the recorded map survey system .