Search results
Results From The WOW.Com Content Network
In building wiring, multiway switching is the interconnection of two or more electrical switches to control an electrical load from more than one location.A common application is in lighting, where it allows the control of lamps from multiple locations, for example in a hallway, stairwell, or large room.
Using actual wires to circuit switch a telephone call became obsolete when the crossbar switch (a mechanical system) was replaced by 4ESS electronic switches in the 1970s by the Bell System in the US. The old telephone hybrids of yore have been replaced by inexpensive IC chip-based components that perform the same functions at greatly reduced cost.
The switches are measured by how many stages, and how many up/down sorters and crosspoints they have. Switches often have buffers built-in for faster switching. A typical switch may have: A 2×2 and 4×4 down sorter [definition needed] Followed by an 8×8 up sorter [definition needed] Followed by a 2×2 crosspoint banyan switch network
Two-way: A simple on-off switch: The two terminals are either connected together or disconnected from each other. An example is a light switch. SPST-NO. Form A [4] Single pole, single throw, normally open A simple on-off switch. The two terminals are normally disconnected (open) and are closed when the switch is activated. An example is a ...
For example, a surface ceiling light is shown by one symbol, a recessed ceiling light has a different symbol, and a surface fluorescent light has another symbol. Each type of switch has a different symbol and so do the various outlets. There are symbols that show the location of smoke detectors, the doorbell chime, and thermostat.
3 Australian light switches and a "neon" indicator—in a 4-gang wall-plate. The lower switch is in the "on" or "down" position. Two Australian rocker switches (disassembled), together with a cutaway view, and a view of the switch connections An Australian architrave-mounted 2-gang switch plate and switches.
Upgrade to a faster, more secure version of a supported browser. It's free and it only takes a few moments:
Wire crossover symbols for circuit diagrams. The CAD symbol for insulated crossing wires is the same as the older, non-CAD symbol for non-insulated crossing wires. To avoid confusion, the wire "jump" (semi-circle) symbol for insulated wires in non-CAD schematics is recommended (as opposed to using the CAD-style symbol for no connection), so as to avoid confusion with the original, older style ...