Ads
related to: hole punch for spiral binding machine near me for sale by owner for rent
Search results
Results From The WOW.Com Content Network
To bind a document, the user first punches holes in the paper with a specialized hole punch. Pages must be punched a few at a time with most of these machines. If hard covers are desired, they must be punched as well. In bulk applications, a paper drilling machine may be used. Then the user chooses a spine size that will match the document.
[citation needed] First, a punch creates holes along the edge of the document. Second, a coil inserter spins the coils through the holes. Third, a pair of coil crimping pliers or a crimping machine is used to cut off the excess coil and crimp the end to prevent the coil from coming loose from the document.
Coil binding uses a spring-like coil, threaded into the punched holes. Comb binding uses a plastic strip with "fingers" that clip into the punched holes. Both use their own types of specialized hole punches. Comb binding typically punches 19 or 23 rectangular holes (for letter and A4 paper sizes, respectively).
Blanking and piercing are shearing processes in which a punch and die are used to produce parts from coil or sheet stock. Blanking produces the outside features of the component, while piercing produces internal holes or shapes. The web is created after multiple components have been produced and is considered scrap material.
This type of binding uses either a 3:1 pitch hole pattern with three holes per inch or a 2:1 pitch hole pattern with two holes per inch. The three to one hole pattern is used for smaller books that are up to 9/16" in diameter while the 2:1 pattern is normally used for thicker books as the holes are slightly bigger to accommodate slightly ...
A stopped hole drilled in the front center portion of the hammer mass facing the tumbler acts as a receiver for the rod, and as an anvil for the punch action. The tumbler provides the automation. When reset, a provision is made such that the tumbler rod is cocked slightly, so that its resting position is skewed and the tip contacts the hammer ...