Search results
Results From The WOW.Com Content Network
A break action is a type of firearm where the barrel(s) are hinged and can be "broken open" to expose the breech. Multi-barrel break action firearms are usually subdivided into over-and-under or side-by-side configurations for two barrel configurations or "combination gun" when mixed rifle and shotgun barrels are used.
A 'locked breech' barrel confines the high-pressure gas to the barrel, allowing the gas to expand and cool without risk of damaging weapon or shooter. Because of the pressure drop, a breech block can be opened in a self-reloading firearm due to the recoil inertia generation by the movement of the projectile.
A typical break-action, double-barreled shotgun. A way of closing the breech or chamber is an essential part of any breech-loading weapon or firearm.Perhaps the simplest way of achieving this is a break-action, in which the barrel, forestock and breech pivot on a hinge that joins the front assembly to the rear of the firearm, incorporating the rear of the breech, the butt and usually, the ...
The earliest breech actions were either three-shot break-open actions or a barrel tip-down, remove the plug and reload actions. The later breech-loaders included the Ferguson rifle , which used a screw-in/screw out action to reload, and the Hall rifle , which tipped up at 30 degrees for loading.
A barrel chamber with pressure relief ports that allows gas to leak around the cartridge during extraction. Basically, the opposite of a fluted chamber, as it is intended for the cartridge to stick to the chamber wall making a slight delay of extraction. This requires a welded-on sleeve with an annular groove to contain the pressure. [8]
Break action is a type of firearm action in which the barrel(s) are hinged much like a door and rotate perpendicularly to the bore axis to expose the breech and allow loading and unloading of cartridges. A separate operation may be required for the cocking of a hammer to fire the new round.
The term BL, in its general sense, stood for breech loading, and contrasted with muzzle loading.The shell was loaded via the breech (i.e. the gunner's end of the barrel, which opened) followed by the propellant charge, and the breech mechanism was closed to seal the chamber.
Some energy is lost in deforming the projectile and causing it to spin. There are also frictional losses between the projectile and the barrel. The projectile, as it travels down the barrel, compresses the air in front of it, which adds resistance to its forward motion. [1] The breech and the barrel must resist the high-pressure gases without ...