Ads
related to: 1 inch pvc female adapter deep hole
Search results
Results From The WOW.Com Content Network
Piping or tubing is usually inserted into fittings to make connections. Connectors are assigned a gender, abbreviated M or F. An example of this is a "3 ⁄ 4-inch female adapter NPT", which would have a corresponding male connection of the same size and thread standard (in this case also NPT).
(In Europe, taper female pipe threads are not commonly used.) Longscrew threads These are parallel pipe threads used where a pressure-tight joint is achieved by the compression of a soft material (such as an o-ring seal or a washer) between the end face of the male thread and a socket or nipple face, with the tightening of a backnut.
The taper rate for all NPT threads is 1 inch of diameter in 16 inches of length (3 ⁄ 4 inch per foot or 62.5 millimeters per meter) measured by the change of diameter (of the pipe thread) over distance of thread. The half-angle (between the taper surface and the axis of the pipe) is arctan(1 ⁄ 32) ≈ 1.7899° ≈ 1° 47′.
These sizing schemes allow for universal adaptation of transitional fittings. For instance, 1/2" PeX tubing is the same size as 1/2" copper tubing. 1/2" PVC on the other hand is not the same size as 1/2" tubing, and therefore requires either a threaded male or female adapter to connect them.
Fire hose used to apply water or other fire fighting agent directly to a fire or burning substance. Typically of 2 + 1 ⁄ 2 inches (64 mm) diameter or less in the United States. Historically 1.5 inch hose was the primary initial attack line but has been supplanted in most of the US by 1.75-inch-diameter (44 mm) hose that carries 175 gallons ...
This fitting is used with 1 ⁄ 2-inch, 5 ⁄ 8-inch, and 3 ⁄ 4-inch hoses. [4] [5] In other countries, a British Standard Pipe (BSP) thread is used, which is 3 ⁄ 4 inch (19 mm) and 14 TPI (male part outside diameter is 26.441 mm or 1.04 in). The GHT and BSP standards are not compatible, and attempting to connect a GHT hose to a BSP fitting ...