Ads
related to: applying wood trim around window on metal building wall bracing plan details
Search results
Results From The WOW.Com Content Network
In light-frame construction, a trimmer is a timber or metal beam (joist) used to create an opening around a stairwell, skylight, chimney, and the like. Trimmers are installed parallel to the primary floor or ceiling joists and support headers, which run perpendicular to the primary joists.
Blocking placed as attachment points for cabinets, while doubling as bracing against compression of the studs. Blocking (dwang, nog, noggin, and nogging) is the use of short pieces of dimensional lumber in wood framed construction to brace longer members or to provide grounds for fixings.
Cladding applied to exterior window and door casing (brick-moulding) and their associated parts is often referred to as window capping or window cladding. This sort of capping is typically applied in order to eliminate the need to re-paint wood window trim. The aluminum capping helps to prevent wood rot by protecting the wood from water and ...
Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a
In construction, a dwang (Scotland and New Zealand), [1] [2] [3] nogging piece, nogging, noggin or nog (England and Australia; all derived from brick nog), [4] [5] or blocking (North America), is a horizontal bracing piece used between wall studs to give rigidity to the wall frames of a building. Noggings may be made of timber, steel, or aluminium.
Wall studs are framing components in timber or steel-framed walls, that run between the top and bottom plates.It is a fundamental element in frame building. The majority non-masonry buildings rely on wall studs, with wood being the most common and least-expensive material used for studs.
Channel or C section girts bolted to plate cleats welded to a portal column in an industrial building. In architecture or structural engineering, a girt, also known as a sheeting rail, is a horizontal structural member in a framed wall. Girts provide lateral support to the wall panel, primarily to resist wind loads. [citation needed]
Crown treatments made out of wood may be a single piece of trim, or a build-up of multiple components to create a more elaborate look. The main element, or the only in a plain installation, is a piece of trim that is sculpted on one side and flat on the other, with standard angles forming 90-degrees milled on both its top and bottom edges.