Ads
related to: bci joist size chart
Search results
Results From The WOW.Com Content Network
Invented in 1969, the I-joist is an engineered wood product that has great strength in relation to its size and weight. The biggest notable difference from dimensional lumber is that the I-joist carries heavy loads with less lumber than a dimensional solid wood joist. [1] As of 2005, approximately 50% of all wood light framed floors used I-joists.
As previously noted, less wood is needed to produce a given finished size than when standards called for the green lumber to be the full nominal dimension. However, even the dimensions for finished lumber of a given nominal size have changed over time. In 1910, a typical finished 1-inch (25 mm) board was 13 ⁄ 16 in (21 mm). In 1928, that was ...
I-beams are still available in US sizes from many Canadian manufacturers. In Mexico , steel I-beams are called IR and commonly specified using the depth and weight of the beam in metric terms. For example, a "IR250x33" beam is approximately 250 mm (9.8 in) in depth (height of the I-beam from the outer face of one flange to the outer face of the ...
Additionally, some manufacturers further cut LVL into sizes for use as chord-members on I-joists. In 2012, North American LVL manufacturers produced more than 1.2 million cubic metres (43.4 million cubic feet) of LVL in 18 different facilities, and in 2013 the production increased by more than 14%.
An I-joist consists of top and bottom flanges of various widths united with webs of various depths. The flanges resist common bending stresses, and the web provides shear performance. [17] I-joists are designed to carry heavy loads over long distances while using less lumber than a dimensional solid wood joist of a size necessary to do the same ...
A double floor is a floor framed with joists supported by larger timbers.. In traditional timber framing there may be a single set of joists which carry both a floor and ceiling called a single floor (single joist floor, single framed floor) or two sets of joists, one carrying the floor and another carrying the ceiling called a double floor (double framed floor).
LH-Series Joists have been standardized in depths from 18 inches (460 mm) through 48 inches (1,200 mm), for spans through 96 feet (29,000 mm). DLH-Series Joists have been standardized in depths from 52 inches (1,300 mm) through 120 inches (3,000 mm), for spans up through 240 feet (73,000 mm).
Wall studs are framing components in timber or steel-framed walls, that run between the top and bottom plates.It is a fundamental element in frame building. The majority non-masonry buildings rely on wall studs, with wood being the most common and least-expensive material used for studs.