Ads
related to: curt hitch fitment chart
Search results
Results From The WOW.Com Content Network
A tow hitch (or tow bar or trailer hitch in North America [1]) is a device attached to the chassis of a vehicle for towing, or a towbar to an aircraft nose gear. It can take the form of a tow ball to allow swiveling and articulation of a trailer , or a tow pin, or a tow hook with a trailer loop, often used for large or agricultural vehicles ...
Engineering fits are generally used as part of geometric dimensioning and tolerancing when a part or assembly is designed. In engineering terms, the "fit" is the clearance between two mating parts, and the size of this clearance determines whether the parts can, at one end of the spectrum, move or rotate independently from each other or, at the other end, are temporarily or permanently joined.
front cover G1 1930. This is the Group G series List of the United States military vehicles by (Ordnance) supply catalog designation, – one of the alpha-numeric "standard nomenclature lists" (SNL) that were part of the overall list of the United States Army weapons by supply catalog designation, a supply catalog that was used by the United States Army Ordnance Department / Ordnance Corps as ...
Each unit of a double-stack car contains a single well; they often are constructed with three to five cars connected by articulated connectors. The intermediate connectors are supported by the centerplate of single trucks, often a 125-short-ton (112-long-ton; 113 t)-capacity truck but sometimes a 150-short-ton (134-long-ton; 136 t)-capacity one.
In mechanical engineering, limits and fits are a set of rules regarding the dimensions and tolerances of mating machined parts if they are to achieve the desired ease of assembly, and security after assembly - sliding fit, interference fit, rotating fit, non-sliding fit, loose fit, etc.
The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than 1 / 4 inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.