Ads
related to: what is spt-1 wire
Search results
Results From The WOW.Com Content Network
1-Wire is a wired half-duplex serial bus designed by Dallas Semiconductor that provides low-speed (16.3 kbit/s [1]) data communication and supply voltage over a single conductor. [ 2 ] 1-Wire is similar in concept to I 2 C , but with lower data rates and longer range.
The standard penetration test (SPT) is an in-situ dynamic penetration test designed to provide information on the geotechnical engineering properties of soil. This test is the most frequently used subsurface exploration drilling test performed worldwide. The test procedure is described in ISO 22476-3, ASTM D1586 [1] and Australian Standards AS ...
Although the construction of a portable cord varies depending on the type, a standard cord has at least two stranded copper conductors sized between #18 and #2 American wire gauge (AWG). The copper stranding, insulation, and outer jacket directly influence the physical properties of the cord and its permitted uses. [1] [2] [3]
NEMA 1-15P (two-pole, no ground) and NEMA 5-15P (two-pole with ground pin) plugs are used on common domestic electrical equipment, and NEMA 5-15R is the standard 15-ampere electric receptacle (outlet) found in the United States, and under relevant national standards, in Canada (CSA C22.2 No. 42 [1]), Mexico (NMX-J-163-ANCE) and Japan (JIS C 8303).
[1] Hot is any line or neutral conductor (wire or otherwise) connected with an electrical system that has electric potential relative to electrical ground or line to neutral. Ground is a safety conductor with a low impedance path to earth. It is often called the "ground wire," or safety ground. It is either bare or has green insulation. [1]
debugWIRE is activated by setting (programming to zero) of the fuse DWEN (debugWIRE enable), normally located in the high fuse byte. After this action the /RESET pin function isn't available anymore and the ISP protocol cannot be used. debugWIRE can be disabled with any of the mentioned debuggers by sending a special reset command that disables temporarily the debugWIRE function and reenables ...