Ads
related to: belt driven generator 1800 rpm parts for free
Search results
Results From The WOW.Com Content Network
Four wool spinning machines driven by belts from an overhead lineshaft (Leipzig, Germany, circa 1925) The belt drives of the Mueller Mill, model and reality, in motionA line shaft is a power-driven rotating shaft for power transmission that was used extensively from the Industrial Revolution until the early 20th century.
Most models were also fitted with a belt-driven Bosch generator for charging the two 12-volt batteries for the 24-volt electric starter motor; and for 12-volt lighting, etc. On 4- and 6-cylinder engines the generator was usually connected by a short drive shaft to the separate belt-driven coolant pump, located close to the cylindrical oil cooler.
An engine–generator is the combination of an electrical generator and an engine (prime mover) mounted together to form a single piece of equipment. This combination is also called an engine–generator set or a gen-set. In many contexts, the engine is taken for granted and the combined unit is simply called a generator. An engine–generator ...
Most engines of the late-19th and early-20th centuries ran at speeds too low to drive a dynamo or alternator directly. As with other equipment, the generator was driven off the engine's flywheel by a broad flat belt. The pulley on the generator was much smaller than the flywheel, providing the required 'gearing up' effect.
At synchronous speed of 1800 RPM, generator will produce no power. When the driving speed is increased to 1860 RPM (typical example), full output power is produced. If the prime mover is unable to produce enough power to fully drive the generator, speed will remain somewhere between 1800 and 1860 RPM range.
The rotor of a turbo generator is a non-salient pole type usually with two poles. [5] The normal speed of a turbo generator is 1500 or 3000 rpm with four or two poles at 50 Hz (1800 or 3600 rpm with four or two poles at 60 Hz). The rotating parts of a turbo generator are subjected to high mechanical stresses because of the high operation speed.