Ads
related to: jeep xj 4 link kit
Search results
Results From The WOW.Com Content Network
The Jeep Cherokee (XJ) is a sport utility vehicle manufactured and marketed across a single generation by Jeep in the United States from 1983 (model year 1984) through 2001 — and globally through 2014. It was available in two- or four-door, five-passenger, front-engine, rear- or four-wheel drive configurations.
Engine bay of a 1993 Jeep Grand Cherokee with 4.0 L The 5 millionth Jeep 4.0 engine produced on the "Greenlee Block Line" dated June 15, 2001 The 242 cu in (4.0 L) engine was developed by AMC in just 26 months using many off-the-shelf components while featuring, among others, additional strength, improved combustion chamber, port setup, and cam ...
In "4-Lo" mode, the input shaft drives through a 2.72:1 reduction planetary gear set and the front and rear axles are locked together through the clutch pack. This same NV247 transfer case is the foundation for the Quadra-Drive system described below. In 2005 Jeep replaced the New Venture Gear NV247 transfer case with the NV245 transfer case ...
The AMC straight-4 engine is a 2.5 L straight-four engine developed by American Motors Corporation (AMC) that was used in a variety of AMC, Jeep, and Dodge vehicles from 1984 through 2002. The 2.5 L I4 Jeep engine shared design elements and some internal components with the AMC 4.0 L I6 that was introduced for the 1987 model year.
Vehicles made by American Motors Corporation (AMC) and Jeep incorporated a variety of transmissions and transfer case systems. This article covers transmissions used in the following vehicle models and years: All American Motors (AMC) passenger cars, 1954-1988; Jeep Cherokee XJ (1984–2001) Jeep Comanche (1986-1992) Jeep CJ (1976–1986)
In the 1960s, Jeep used a unique Dana 44 IFS setup, that was short lived. In the 1980s and 1990s, Ford used a form of IFS known as " Twin Traction Beam " (TTB). This Dana 44 had no axle tubes but attached to the driver side traction beam, which also acted as a cover plate, and had "open air" axles which traveled through the beams to the spindles.