Search results
Results From The WOW.Com Content Network
It is especially popular as a unit of measurement with shooters familiar with the imperial measurement system because 1 MOA subtends a circle with a diameter of 1.047 inches (which is often rounded to just 1 inch) at 100 yards (2.66 cm at 91 m or 2.908 cm at 100 m), a traditional distance on American target ranges.
The basic unit of length in the imperial and U.S. customary systems is the yard, defined as exactly 0.9144 m by international treaty in 1959. [2] [10] Common imperial units and U.S. customary units of length include: [11] thou or mil (1 ⁄ 1000 of an inch) inch (25.4 mm) foot (12 inches, 0.3048 m) yard (3 feet, 0.9144 m)
Subtension refers to the length between two points on a target, and is usually given in either centimeters, millimeters or inches. Since an mrad is an angular measurement, the subtension covered by a given angle (angular distance or angular diameter) increases with viewing distance to the target. For instance the same angle of 0.1 mrad will ...
For example, if a ruler's smallest mark is 0.1 cm, and 4.5 cm is read, then it is 4.5 (±0.1 cm) or 4.4 cm to 4.6 cm as to the smallest mark interval. However, in practice a measurement can usually be estimated by eye to closer than the interval between the ruler's smallest mark, e.g. in the above case it might be estimated as between 4.51 cm ...
A unit of measurement, or unit of measure, is a definite magnitude of a quantity, defined and adopted by convention or by law, that is used as a standard for measurement of the same kind of quantity. [1] Any other quantity of that kind can be expressed as a multiple of the unit of measurement. [2] For example, a length is a physical quantity.
For example, a length that is significantly longer or shorter than 1 metre can be represented in units that are a power of 10 or 1000 metres. This differs from many older systems in which the ratio of different units varied. For example, 12 inches is one foot, but the larger unit in the same system, the mile is not a power of 12 feet. It is ...
A small number of gauge blocks can be used to create accurate lengths within a wide range. By using three blocks at a time taken from a set of 30 blocks, one may create any of the 1000 lengths from 3.000 to 3.999 mm in 0.001 mm steps (or .3000 to .3999 inches in 0.0001 inch steps).
These spools and their attendant parts are held inside a protective plastic shell which is 4 by 2.5 by 0.5 inches (10.2 cm × 6.35 cm × 1.27 cm) at its largest dimensions. The tape itself is commonly referred to as "eighth-inch" tape, supposedly 1 ⁄ 8 inch (0.125 in; 3.17 mm) wide, but actually slightly larger, at 0.15 inches (3.81 mm). [8]