Search results
Results From The WOW.Com Content Network
All oil tankers with a gross tonnage of larger than 150 must have efficient Oil Discharge Monitoring Equipment on board. [3] [4] The oily discharge is sent out to sea through a pump. [5] The oily mixture has to pass through a series of sensors to determine whether it is acceptable to be sent to the discharge pipe. [6]
The oil content meter will sound an alarm if the liquid leaving the system has an unsatisfactory amount of oil in the mixture. If it is still above that standard, then the bilge water will be reentered into the system until it meets the required criteria. The OCM uses light beams to determine how oily the water in the system is. [4] The system ...
Hydro ASA acquired Sapa in October 2017, when Sapa was renamed Hydro Extruded Solutions and organized as a new business area. [ 6 ] In 2019 a NASA investigation of two Taurus rocket launch failures, which resulted in the loss of 700 million dollars worth of payload, determined that the root cause was the use of defective parts manufactured and ...
Hydronics (from Ancient Greek hydro- 'water') is the use of liquid water or gaseous water or a water solution (usually glycol with water) as a heat-transfer medium in heating and cooling systems. [1] [2] The name differentiates such systems from oil and refrigerant systems.
There are however standards in place for fiscal automatic sampling of crude oil namely API 8.2 and ISO 3171. [1] Water cut meters are typically used in the petroleum industry to measure the water cut of oil flowing from a well, produced oil from a separator, crude oil transfer in pipelines and in loading tankers. There are several technologies ...
Hydronic balancing, also called hydraulic balancing, is the process of optimizing the distribution of water in a building's hydronic heating or cooling system by equalizing the system pressure. In a balanced system every radiator is set to receive the proper amount of fluid in order to provide the intended indoor climate at optimum energy ...
In low pressure the tube is slightly pressurized to a fixed volume during the closing of the die (this used to be called the Variform process). Historically, the process was patented in the '50s, [7] but it was industrially spread in the 1970s for the production of large T-shaped joints for the oil and gas industry. Today it is mostly used in ...
Aluminium hydroxide gels can be dehydrated (e.g. using water-miscible non-aqueous solvents like ethanol) to form an amorphous aluminium hydroxide powder, which is readily soluble in acids. Heating converts it to activated aluminas, which are used as desiccants , adsorbent in gas purification, and catalyst supports .