Ads
related to: 3.8 pushrod engine reviews consumer reports complaints
Search results
Results From The WOW.Com Content Network
The engines were produced in two major variants differing by their piston displacement: a 3.3 L; 201.4 cu in (3,301 cc) and a 3.8 L; 230.5 cu in (3,778 cc). The 3.3 was dropped after 2010 with the Chrysler minivans, and the 3.8 was dropped after 2011 with the Jeep Wrangler, ending 22 years in production.
The roomy LaCrosse is available with GM's proven 3.8-liter pushrod V-6. while the 2009 Ultimate New Car Guide from the editors of Automobile are more specific on page 36: GM's old workhorse iron block pushrod 3.8-liter V-6 pulls engine duty for CX and CXL models, but it is coarse and noisy at high engine speeds.
It remains one of the worst vehicles Consumer Reports has ever tested. [40] The publication noted that the car took 37.5 seconds to go from 0–60 MPH, it was dangerously structurally deficient in a 30MPH crash test with a standard car, and its bumpers were "virtually useless against anything more formidable than a watermelon ", all of which ...
This engine used a provision in the rules intended for stock block pushrod engines such as the V-6 Buick engines that allowed an extra 650 cm³ and 10 inches (4.9 psi/33.8 kPa) of boost. This extra power (1,024 horsepower , [ 15 ] which was up a 150-200 hp advantage over the conventional V-8s.
Wards 10 Best Engines is an annual list of the ten "best" automobile engines available in the U.S. market, that are selected by Wards AutoWorld magazine. The list was started in 1994 for model year 1995, and has been drawn every year since then, published at the end of the preceding year.
Years of elevated inflation and the highest interest rates in almost a quarter century are wearing out the US consumer. Savings accumulated during the Covid-19 pandemic are drying up, borrowers ...
The L67 and L36 do not share pistons. L67 pistons are heavier and have a different height to lower compression. Both engines share the same engine blocks, but compression is reduced from 9.4:1 in the L36 to 8.5:1 for the L67. GM listed the engine output as 240 hp (179 kW) and 280 lb⋅ft (380 N⋅m) of torque.
The Pentastar engine was introduced at the 2009 New York Auto Show. [2] [3] The engine design allows the use of E85 or 87 octane fuel and features dual variable valve timing. Forced induction, and cylinder deactivation options were engineered into the engine design, but have not been implemented from the factory, remaining "on the shelf" as of ...