When.com Web Search

  1. Ads

    related to: 80000 gpd to gpm change formula for water pump

Search results

  1. Results From The WOW.Com Content Network
  2. Gallon per watt-hour - Wikipedia

    en.wikipedia.org/wiki/Gallon_per_watt-hour

    Residential pool pumps were first included in the 2005 Title-20 appliance standards that were adopted at the end of 2005. California has a limited ability to produce electricity. When California electrical demand exceeds its production capacity the utility companies must purchase electricity, usually form out of state companies at a much higher ...

  3. Volumetric flow rate - Wikipedia

    en.wikipedia.org/wiki/Volumetric_flow_rate

    Volumetric flow rate is defined by the limit [3] = ˙ = =, that is, the flow of volume of fluid V through a surface per unit time t.. Since this is only the time derivative of volume, a scalar quantity, the volumetric flow rate is also a scalar quantity.

  4. Airlift pump - Wikipedia

    en.wikipedia.org/wiki/Airlift_pump

    10. pump outlet L: liquid, usually wastewater LL: liquid level V: Vessel G: Gravel or solids. An airlift pump is a pump that has low suction and moderate discharge of liquid and entrained solids. The pump injects compressed air at the bottom of the discharge pipe which is immersed in the liquid.

  5. Specific pump power - Wikipedia

    en.wikipedia.org/wiki/Specific_pump_power

    Specific Pump Power (SPP) is a metric in fluid dynamics that quantifies the energy-efficiency of pump systems. It is a measure of the electric power that is needed to operate a pump (or collection of pumps), relative to the volume flow rate. It is not constant for a given pump, but changes with both flow rate and pump pressure.

  6. Hazen–Williams equation - Wikipedia

    en.wikipedia.org/wiki/Hazen–Williams_equation

    S foot of water per foot of pipe; P d = pressure drop over the length of pipe in psig (pounds per square inch gauge pressure) L = length of pipe in feet; Q = flow, gpm (gallons per minute) C = pipe roughness coefficient; d = inside pipe diameter, in (inches) Note: Caution with U S Customary Units is advised. The equation for head loss in pipes ...

  7. Comparison of pumps - Wikipedia

    en.wikipedia.org/wiki/Comparison_of_pumps

    Different types of pumps are suitable for different applications, for example: a pump's maximum lift height also determines the applications it can be used for. Low-lift pumps are only suitable for the pumping of surface water (e.g., irrigation, drainage of lands, ...), while high-lift pumps allow deep water pumping (e.g., potable water pumping ...