Search results
Results From The WOW.Com Content Network
A tachometer that can indicate up to 7000 RPM (left) A tachometer (revolution-counter, tach, rev-counter, RPM gauge) is an instrument measuring the rotation speed of a shaft or disk, as in a motor or other machine. [1] The device usually displays the revolutions per minute (RPM) on a calibrated analogue dial, but digital displays are ...
Timing light, combination instrument with RPM, volt meter and dwell angle meter. The actual light is on the far end. The black clamp connects to the battery -, the red clamp to +, the green one to the breaker side of the coil (for RPM), the big black clamp in the foreground is an inductive pick-up that clamps around a spark plug wire.
Dwell time (T D) in surveillance radar is the time that an antenna beam spends on a target. [1] The dwell time of a 2D–search radar depends predominantly on the antenna's horizontal beam width θ AZ, and; the turn speed n of the antenna (in rotations per minute or rpm, i.e. 360 degrees in 60 seconds = multiplied by a factor of 6).
A single dwell linkage takes advantage of the behavior of a link with a stationary revolute (hinge) or prismatic (sliding) joint and its interaction with special coupler curves. There are two methods of producing a single-dwell: arc-based and linear-based. An arc-based single dwell linkage uses the approximation of a circular arc.
A simple displacement diagram illustrates the follower motion at a constant velocity rise followed by a similar return with a dwell in between as depicted in figure 2. [4] The rise is the motion of the follower away from the cam center, dwell is the motion where the follower is at rest, and return is the motion of the follower toward the cam ...
An SWR meter does not measure the actual impedance of a load (the resistance and reactance), but only the mismatch ratio. To measure the actual impedance requires an antenna analyzer or other similar RF measuring device. For accurate readings, the SWR meter itself must also match the line's impedance (typically 50 or 75 Ohms).
A Hobbs Meter made by General Electric about 1970. Hobbs meter is a generic trademark for devices used in aviation to measure the time that an aircraft is in use. The meters typically display hours and tenths of an hour, but there are several ways in which the meter may be activated: It can measure the time that the electrical system is on.
An auto tachometer has a sweep of about 240-250 degrees and typically uses an air core gauge. An air core gauge is a specific type of rotary actuator in an analog display gauge that allows an indicator to rotate a full 360 degrees. It is used in gauges and displays, most commonly automotive instrument clusters.