Search results
Results From The WOW.Com Content Network
There are, however, components of electrical circuits which do not obey Ohm's law; that is, their relationship between current and voltage (their I–V curve) is nonlinear (or non-ohmic). An example is the p–n junction diode (curve at right). As seen in the figure, the current does not increase linearly with applied voltage for a diode.
The current–voltage graph of an ohmic device consists of a straight line through the origin with positive slope. Other components and materials used in electronics do not obey Ohm's law; the current is not proportional to the voltage, so the resistance varies with the voltage and current through them. These are called nonlinear or non-ohmic.
Voltage drop exists in both the supply and return wires of a circuit. If the voltage drop across each resistor is measured, the measurement will be a significant number. That represents the energy used by the resistor. The larger the resistor, the more energy used by that resistor, and the bigger the voltage drop across that resistor.
The volt-ampere (SI symbol: VA, [1] sometimes V⋅A or V A) is the unit of measurement for apparent power in an electrical circuit. It is the product of the root mean square voltage (in volts) and the root mean square current (in amperes). [2] Volt-amperes are usually used for analyzing alternating current (AC) circuits.
In a superconductor, the resistance drops abruptly to zero when the material is cooled below its critical temperature. In a normal conductor, the current is driven by a voltage gradient, whereas in a superconductor, there is no voltage gradient and the current is instead related to the phase gradient of the superconducting order parameter. [15]
The formula is a combination of Ohm's law and Joule's law: = = =, where P is the power, R is the resistance, V is the voltage across the resistor, and I is the current through the resistor. A linear resistor has a constant resistance value over all applied voltages or currents; many practical resistors are linear over a useful range of currents.
In a circuit with a three terminal device, such as a transistor, the current–voltage curve of the collector-emitter current depends on the base current. This is depicted on graphs by a series of (I C –V CE) curves at different base currents. A load line drawn on this graph shows how the base current will affect the operating point of the ...
When the current is a linear function of the voltage, the device is said to have ohmic contacts. Inductive and capacitive methods could be used in principle to measure an intrinsic impedance without the complication of contact resistance. In practice, direct current methods are more typically used to determine resistance.