Search results
Results From The WOW.Com Content Network
Where the modulus M is the ratio of the casting's volume to its surface area: M = V A {\displaystyle M={\frac {V}{A}}} The mold constant B depends on the properties of the metal, such as density, heat capacity , heat of fusion and superheat, and the mold, such as initial temperature, density, thermal conductivity , heat capacity and wall thickness.
The Atterberg limits are a basic measure of the critical water contents of a fine-grained soil: its shrinkage limit, plastic limit, and liquid limit. Depending on its water content, soil may appear in one of four states: solid, semi-solid, plastic and liquid. In each state, the consistency and behavior of soil are different, and consequently so ...
To separate shrinkage from creep, the compliance function (, ′), defined as the stress-produced strain (i.e., the total strain minus shrinkage) caused at time t by a unit sustained uniaxial stress = applied at age ′, is measured as the strain difference between the loaded and load-free specimens.
A bronze casting showing the sprue and risers. A riser, also known as a feeder, [1] is a reservoir built into a metal casting mold to prevent cavities due to shrinkage.Most metals are less dense as a liquid than as a solid so castings shrink upon cooling, which can leave a void at the last point to solidify.
The result of fitting a set of data points with a quadratic function Conic fitting a set of points using least-squares approximation. In regression analysis, least squares is a parameter estimation method based on minimizing the sum of the squares of the residuals (a residual being the difference between an observed value and the fitted value provided by a model) made in the results of each ...
Equilibration (usually drying) causes unequal shrinkage in the wood, and can cause damage to the wood if equilibration occurs too rapidly. The equilibration must be controlled to prevent damage to the wood. [citation needed] Wood burning When wood is burned , it is usually best to dry it first. Damage from shrinkage is not a problem here, as it ...
In statistics, shrinkage is the reduction in the effects of sampling variation. In regression analysis , a fitted relationship appears to perform less well on a new data set than on the data set used for fitting. [ 1 ]
Material efficiency is a description or metric ((Mp) (the ratio of material used to the supplied material)) which refers to decreasing the amount of a particular material needed to produce a specific product. [1] Making a usable item out of thinner stock than a prior version increases the material efficiency of the manufacturing process.