When.com Web Search

Search results

  1. Results From The WOW.Com Content Network
  2. Hot Standby Router Protocol - Wikipedia

    en.wikipedia.org/wiki/Hot_Standby_Router_Protocol

    Hot Standby Router Protocol. In computer networking, the Hot Standby Router Protocol (HSRP) is a Cisco proprietary redundancy protocol for establishing a fault-tolerant default gateway. Version 1 of the protocol was described in RFC 2281 in 1998. Version 2 of the protocol includes improvements and supports IPv6 but there is no corresponding RFC ...

  3. Common Address Redundancy Protocol - Wikipedia

    en.wikipedia.org/wiki/Common_Address_Redundancy...

    The Common Address Redundancy Protocol or CARP is a computer networking protocol which allows multiple hosts on the same local area network to share a set of IP addresses. Its primary purpose is to provide failover redundancy, especially when used with firewalls and routers. In some configurations, CARP can also provide load balancing ...

  4. Virtual Router Redundancy Protocol - Wikipedia

    en.wikipedia.org/wiki/Virtual_Router_Redundancy...

    Virtual Router Redundancy Protocol. The Virtual Router Redundancy Protocol (VRRP) is a computer networking protocol that provides for automatic assignment of available Internet Protocol (IP) routers to participating hosts. This increases the availability and reliability of routing paths via automatic default gateway selections on an IP subnetwork.

  5. High-availability Seamless Redundancy - Wikipedia

    en.wikipedia.org/wiki/High-availability_Seamless...

    High-availability Seamless Redundancy. High-availability Seamless Redundancy (HSR) is a network protocol for Ethernet that provides seamless failover against failure of any single network component. PRP and HSR are independent of the application-protocol and can be used by most Industrial Ethernet protocols in the IEC 61784 suite.

  6. Parallel Redundancy Protocol - Wikipedia

    en.wikipedia.org/wiki/Parallel_Redundancy_Protocol

    Parallel Redundancy Protocol. Parallel Redundancy Protocol (PRP) is a network protocol standard for Ethernet that provides seamless failover against failure of any network component. This redundancy is invisible to the application. PRP nodes have two ports and are attached to two separated networks of similar topology.

  7. Failover - Wikipedia

    en.wikipedia.org/wiki/Failover

    Failover. Failover is switching to a redundant or standby computer server, system, hardware component or network upon the failure or abnormal termination of the previously active application, [1] server, system, hardware component, or network in a computer network. Failover and switchover are essentially the same operation, except that failover ...

  8. Type C videotape - Wikipedia

    en.wikipedia.org/wiki/Type_C_videotape

    Type C videotape. 1-inch Type C Helical Scan or SMPTE C is a professional reel-to-reel analog recording helical scan videotape format co-developed and introduced by Ampex and Sony in 1976. It became the replacement in the professional video and broadcast television industries for the then-incumbent 2-inch quadruplex videotape (2-inch Quad for ...

  9. Anycast - Wikipedia

    en.wikipedia.org/wiki/Anycast

    Anycast is a network addressing and routing methodology in which a single IP address is shared by devices (generally servers) in multiple locations. Routers direct packets addressed to this destination to the location nearest the sender, using their normal decision-making algorithms, typically the lowest number of BGP network hops.