Ads
related to: what is a speed sensor bufferyourmechanic.com has been visited by 10K+ users in the past month
Search results
Results From The WOW.Com Content Network
The first pair, the Overspeed Sensor System (OSS), is sited at a position determined by line speed and gradient. The loops are separated by a distance that should not be traversed within less than a pre-determined period of time of about one second if the train is running at a safe speed approaching the signal at danger.
Buffer amplifier. In electronics, a buffer amplifier is a unity gain amplifier that copies a signal from one circuit to another while transforming its electrical impedance to provide a more ideal source (with a lower output impedance for a voltage buffer or a higher output impedance for a current buffer). This "buffers" the signal source in the ...
Push–pull output. A push–pull amplifier is a type of electronic circuit that uses a pair of active devices that alternately supply current to, or absorb current from, a connected load. This kind of amplifier can enhance both the load capacity and switching speed.
Open collector, open drain, open emitter, and open source refer to integrated circuit (IC) output pin configurations that process the IC's internal function through a transistor with an exposed terminal that is internally unconnected (i.e. "open"). One of the IC's internal high or low voltage rails typically connects to another terminal of that ...
Serial Clock. CS. Chip Select (one or more) (pins may have alternative names) Serial Peripheral Interface (SPI) is a de facto standard (with many variants) for synchronous serial communication, used primarily in embedded systems for short-distance wired communication between integrated circuits. SPI follows a master–slave architecture, [1 ...
The most common wheel speed sensor system consists of a ferromagnetic toothed reluctor ring (tone wheel) and a sensor (which can be passive or active). The tone wheel is typically made of steel and may be an open-air design, or sealed (as in the case of unitized bearing assemblies). The number of teeth is chosen as a trade-off between low-speed ...